Abstract:A supercritical carbon dioxide (S-CO2) and Organic Rankine Cycle (ORC) combined cycle has been considered to fully use the residual heat of a high temperature heat source in this paper. The topping cycle is a S-CO2 recompression cycle, and the bottoming cycle is an ORC with R245fa as the working fluid. Compared with previous studies, the influence of several additional parameters, including the S-CO2 recompression cycle main compressor inlet temperature and pressure and the S-CO2 recompression cycle split ratio, has been conducted. It indicates that the split ratio plays an important role on the S-CO2 recompression cycle, even on the combined cycle. A thermodynamic optimization method which considers the split ratio is proposed to maximum the combined cycle thermal efficiency. By this method, more than 4.1% increment on the thermal efficiency can be attained. INTRODUCTION The supercritical carbon dioxide (S-CO2) is a special kind of CO2 fluid whose temperature and pressure are higher than its critical values (304.13K, 7.38 MPa). The S-CO2 cycle, which uses S-CO2 as the working fluid, is considered to be one of the most promising power generation technologies for the future (Feher, 1968). The S-CO2 cycle has higher efficiency and more compact system and components than conventional power cycles, especially in the high temperature range. Besides, CO2 is easy to obtain and the S-CO2 cycle system has high safety level. It is widely acknowledged that the S-CO2 cycle is applicable for various heat sources, such as the nuclear energy (Moisseytsev and Sienicki, 2009), concentrated solar power (Turchi and Ma, 2012), fuel cell (Xia et al., 2019) and waste heat recovery (Song et al., 2018a). One of the S-CO2 cycle characteristics is that the specific heat capacity of the cold side flow is much higher than that of the hot side in recuperators. For the S-CO2 recompression cycle, the CO2 flow is split to compensate for the specific heat difference in the low temperature recuperator and to further enhance the heat recuperation in the high temperature recuperator. Therefore, the residual heat is decreased and the S-CO2 recompression cycle has higher efficiency than simple recuperated cycle. The S-CO2 recompression cycle has been adopted by National Energy Technology Laboratory (NETL) of U.S. DOE for Supercritical Transformational Electric Power (STEP) program (Lambruschini et al., 2016).

Optimal design and thermodynamic evaluation of supercritical CO 2 oxy-coal circulating fluidized bed power generation systems

Thermodynamic Analysis of Coal-Fired Thermal Power Units Coupled S-CO2 Energy Storage System

300 MW boiler design study for coal-fired supercritical CO2 Brayton cycle

Effect of flue gas cooler and overlap energy utilization on supercritical carbon dioxide coal fired power plant

The roadmap towards the efficiency limit for supercritical carbon dioxide coal fired power plant

Multi-objective optimization of supercritical CO 2 Brayton cycles for coal-fired power generation with two waste heat recovery schemes

Optimization study on improving energy efficiency of power cycle system of staged coal gasification coupled with supercritical carbon dioxide

Numerical analysis and modified thermodynamic calculation methods for the furnace in the 1000 MW supercritical CO2 coal-fired boiler

Performance Improvement Overview of the Supercritical Carbon Dioxide Brayton Cycle

Thermodynamic Analysis and Optimization of a Supercritical Carbon Dioxide (S-CO2) Recompression Cycle Coupled with a Bottoming Organic Rankine Cycle

Design optimization and off-design performance analysis of one-dimensional supercritical CO 2 Brayton cycle

Off-design performance analysis of supercritical CO 2 mixture Brayton cycle with floating critical points

Conceptual Design Of An 800mwe Supercritical Pressure Circulating Fluidized Bed Boiler And Its Performance Prediction

Influence of Supercritical Carbon Dioxide Brayton Cycle Parameters on Intelligent Circulation System and Its Optimization Strategy

The comprehensive solution to decrease cooling wall temperatures of sCO2 boiler for coal fired power plant

Design and optimization of waste heat recovery system for supercritical carbon dioxide coal-fired power plant to enhance the dust collection efficiency

System Modification and Thermal Efficiency Study on the Semi-Closed Cycle of Supercritical Carbon Dioxide

Design and performance analysis of compressor and turbine in supercritical CO2 power cycle based on system-component coupled optimization

An adaptive CO 2 Brayton-Rankine power cycle for efficient utilization of low environment temperature: A thermodynamic analysis and optimization study

Optimization of Fluidization State of a Circulating Fluidized Bed Boiler for Economical Operation

Process Synthesis of an S-CO2Brayton Cycle Operating at an Ultra-Supercritical Steam Cycle Level