Abstract:This study introduces a methodology to compute spray cooling in the nucleate boiling regime. It examines the cooling of a horizontal circular tube, although the approach is not restricted to this geometry. While numerous investigations have considered nucleate boiling in the past, these are usually restricted to spray impingement onto a flat plate and not onto more complex surfaces. Furthermore, most prior studies are highly empirical in nature. The present study circumvents both of these restrictions. On the one hand, with more complex surfaces additional factors must be considered, in particular the influence of the local impingement angle on the number flux of impinging drops. On the other hand, the heat transfer for single droplets is first computed using existing theoretical solutions and then the principle of superposition is used to compute the global heat transfer from the surface over which the spray impinges. Accompanying this computation, a drop size distribution is specified in order to also investigate the influence of not only one representative drop size, but also the variance of drop size distribution on the heat transfer, an influence seldom reported on. Furthermore, the probability of drop-drop interaction on the surface has been estimated and the heat transfer correspondingly adjusted. This approach of computing total net heat transfer on a surface is first validated using available measurements in which the heat transfer in the nucleate boiling regime from a flat plate were used for comparison. The heat transfer from a circular tube was then computed as a function of mass flow rate, drop size distribution (expectation and variance) and wall temperature. Conditions for maximum heat transfer, corresponding to the critical heat flux, were identified. In all cases the net heat transfer was limited by the onset of drop-drop interaction on the substrate, i.e. the net coverage of liquid on the surface. The results of these parametric studies indicate clearly how the mass flow rate can be adjusted to maximize heat transfer while avoiding excess fluid consumption. Furthermore, the Sauter mean diameter is shown to be an appropriate drop size to use, if no further information is available concerning the size distribution.

Processes Occurring in a Coolant Spray Cone

Experimental Study on a Spray and Falling-Film Cooling System

Numerical Study on Flow Structures of a Hollow Cone Spray in Crossflow

Modeling of Micro- and Nanoparticle Characteristics in DC Suspension Plasma Spray

Three-Dimensional Simulation Of Effervescent Atomization Spray

Dynamics and heat transfer characteristics of isolated liquid film in spray cooling

Droplets Behavior of Hollow-Cone Spray in a Non-Condensable Environment

Study on Instability Breakup of Fluid Droplet in Spray Process

Droplet Dispersion Characteristics of the Hollow Cone Sprays in Crossflow

Flow Behavior and Heat Transfer of Atomizing Gas and Metal Droplets in Spray Forming Process

Simulations of Non-Reacting Transient N-Dodecane Spray in a High-Pressure Combustion Vessel

Particle cooling in Vaporizing Coolant

Methodology to compute spray cooling in the nucleate boiling regime

Parametric study of water spray cooling on enhanced relatively large surfaces

Simulation of Full Cone Nozzle Spray Cooling Performance in Single Phase

Spray characteristics and spray cooling heat transfer in the non-boiling regime

The Two-Phase High-Speed Stream at the Centerline of a Hollow-Cone Spray Produced by a Pressure-Swirl Nozzle

Spray Cooling and Flash Evaporation Cooling: the Current Development and Application

Experimental Study on Breakup Characteristics of Hollow Cone Spray in Gas Crossflow

THEORETICAL AND EXPERIMENTAL INVESTIGATION OF HEAT TRANSFER PERFORMANCE OF SPRAY COOLING UNDER LOW MASS FLUX

Fast transient spray cooling of a hot thick target