Abstract:This paper presents a set of differential and algebraic equations that model heat and mass transfer in condensers in which a mixture of water vapor and non-condensable gas is cooled. The model has been used to predict the condensation rate, the bulk temperatures of the coolant and the gas–vapor mixture, and the surface temperatures of the condenser wall. The predicted results for counter flow tube condensers are compared with three sets of published experimental data for system in which air is the non-condensable gas. It is found that the predicted condensation rates and coolant bulk temperatures agree very well with all the three sets of experimental data, the predicted wall temperatures agree reasonably well with the experimental results, and the agreement between the predictions and the experimental results on the bulk temperature of the air–vapor mixture is excellent for one set of the experimental data, reasonable for the second set of experimental data, but poor for the third set of experimental data. It is suggested that the poor agreement between the predicted and measured bulk temperatures of the mixture for the third set of experimental data arises from the experimental errors. The results from this study show that when modeling vapor condensation in the presence of a non-condensable gas, a simple model for the mixture channel alone may not be sufficient since neither the temperature nor the heat flux at the wall can be assumed to be constant. The results also show that the wall temperature in the coolant channel can be quite high, and careful modeling of the heat transfer in the coolant channel is needed in order to achieve good agreement between the model predictions and the experimental results.

Particle cooling in Vaporizing Coolant

Evaporation Drag Model of High Temperature Particles Moving Inside Coolant

A Model of Film Boiling Thermal Hydraulics on a Hot Particle Dropping in Coolant Liquid

Modeling Droplet Vaporization and Combustion with the Volume of Fluid Method at a Small Reynolds Number

Numerical Simulation of Flow Around a Hot Particle With a Vapor Film Using a Volume-of-Fluid Interface Tracking Method

Modeling gasodynamic vortex cooling

A Coupled Vaporization Model Based on Temperature/species Gradients for Detailed Numerical Simulations Using Conservative Level Set Method

Experimental study of heat and dynamic characteristics of hot particles moving in coolant under film boiling condition

An Experimental Study on the Movement Mechanism of the High-Temperature Particles Falling into the Coolant Pool

Condensation of vapor in the presence of non-condensable gas in condensers

Vaporization dynamics of a super-heated water-in-oil droplet: modeling and numerical solution

Processes Occurring in a Coolant Spray Cone

Model of Thermal State of the System of Application of Coolant in Grinding Machine

Study on Water Droplet Flash Evaporation in Vacuum Spray Cooling

A Numerical Model for Simulating the Droplet Flow and Evaporation

Model and Powder Particle Heating, Melting, Resolidification, and Evaporation in Plasma Spraying Processes

A reduced model for compressible viscous heat-conducting multicomponent flows

A New Liquid Model for Droplet Evaporation

A New Model and its Application to Investigate Transpiration Cooling with Liquid Coolant Phase Change

Numerical simulation of natural cooling vapor chamber

A modified local thermal non-equilibrium model of transient phase-change transpiration cooling for hypersonic thermal protection