Abstract:Superheated droplets vaporized in a vacuum or vapor chamber was studied using smoothed particle hydrodynamics method.The two-phase fluids of vapor and liquid with a diffused interface were modeled by Navier-Stokes-Korteweg equations,with the van der Waals equation of state.The liquid-vapor separation was processed with different initial temperature and density.Simulation was firstly validated by the proper equilibrium states with analytical data from the binodal line of Maxwell construction,as well as the droplet surface tension compared with experimental and other groups'numerical data in a good agreement.Droplet morphology,density,temperature and entropy increment were then carefully examined during the dynamic process from evaporation to boiling.Four phase transitions patterns were concluded,namely from surface evaporation,internal bubble,fragment and explosion,to flash boiling with increasing equivalent superheat degree that is defined by the non-dimensional superheat temperature over surface tension.Results showed that droplet temperature and density decreased slightly at surface evaporation when equivalent superheat degree was lower than 1/3.Above this criterion,the internal bubble could be sustained.Growth of new liquid nucleates and connected secondary liquid ring were calculated by domain growth theory.We found that droplet continuous to expand at high superheat but withdrawn at equivalent superheat degree equal to or lower than 0.52.At equivalent superheat degree higher than 1,the growth and expansion of droplet resulted in liquid fragment and explosion to many small secondary droplets.Mean mass and diameter of these droplets were found to have power-law dependency on the expansion rate.Finally,fast flash boiling occurred at equivalent superheat degree higher than 3.The vapor pressure in the chamber showed a negative linear correlation between the overpressure and the atmospheric pressure.We also found out that comparing to increase the pressure value,dense gas had better efficiency on retarding the propagation of shock wave.

Study on Water Droplet Flash Evaporation in Vacuum Spray Cooling

Experimental Investigation of Spray Cooling Performance in Non‐boiling Zone on Rough Superhydrophilic/hydrophobic Surfaces

ICOPE-15-C064 Numerical Analysis of a Single Water Droplet Evaporation Caused by Laser Radiation

Numerical Investigation of the Flow Dynamics and Evaporative Cooling of Water Droplets Impinging Onto Heated Surfaces: an Effective Approach to Identify Spray Cooling Mechanisms

Experimental Study on a Spray and Falling-Film Cooling System

Droplet Evaporation to Boiling in Van Der Waals Fluid

Experimental study of two-phase heat transfer of droplet impact on liquid film

Visualization Study on Atomization Characteristics and Heat Transfer Performance of R1336mzz Flash Spray Cooling

Dropwise Evaporative Cooling of Heated Surfaces with Various Wettability Characteristics Obtained by Nanostructure Modifications

Simulation of Mass and Heat Transfer of Droplets Collision in a Flash Evaporation Pattern

Thin liquid film flow and heat transfer under spray impingement

CFD-Based Numerical Simulation of Water Film Flash Evaporation with a New Flash Evaporation Model

Quantitative investigation of the evaporation and resistance characteristics of inlet jet precooling

Three-dimensional simulation of flash evaporation of non-uniform spray in saturated vapor environment

Experimental and numerical simulation study on the mass transfer characteristics of static flash evaporation

Evolution and heat transfer after droplet impact on heated liquid film with vapor bubbles inside

Analysis of the effects of evaporative cooling on the evaporation of liquid droplets using a combined field approach

Experimental Study on Spray Cooling under Reduced Pressures

Research Progresses of Flash Evaporation in Aerospace Applications

Effect of Droplets on Water Vapor Compression Performance

Transient heat transfer characteristics in spray cooling