Abstract:Spray cooling features with high heat flux and good temperature control ability, which has been widely used in industrial environments such as electronic devices and nuclear power plants. In this study, the transient process of droplet-wall collision under film and transition boiling conditions has been investigated experimentally via the high-speed shadowgraph imaging and state-of-the-art image processing techniques. Based on intensive test conditions, the impact morphology, number, size, trajectory, ejecting angle and velocity of secondary droplets are presented and analyzed comprehensively. In experiments, distilled water was the test fluid, with initial droplets at 3 ± 0.03 mm. Droplet collision velocity was calculated based on the center distance in two pre-collision frames. The Weber number changes from 15.4 to 104.2, while the wall temperature varies from 307.6 °C to 511.8 °C. The observed collision phenomena can be divided into four types, including rebound, rebound with secondary atomization, breakup with secondary atomization, and breakup. An Improved Cascade Gaussian Fitting method (ICGF), which performs well in the dense and mutually occlusive areas, is adopted for particle identification. The statistical results show that the secondary droplet diameter mainly distributes in the range of 0.02 mm to 0.2 mm under different Weber numbers. Under similar wall temperature conditions, the number of secondary droplets and the average diameter of secondary droplets increase with Weber number. Moreover, the separation mass ratio increased from 0.18 % to 2.29 %. Specifically, it is found that the amount and size of secondary droplets decrease significantly when the boiling mode transfers from transition to film. Based on the time-resolved shadowgraph images, a four-frame optimal estimation particle tracking algorithm is used to obtain the two-dimensional trajectory of the secondary droplets. The measured velocity distributes in the range of 0.3 m/s-4.0 m/s, mainly concentrating in the range of 0.5 m/s-2.0 m/s. The number and size variation with time is also analyzed, which indicates most of the secondary droplets are generated due to the strong instability in the transition boiling states.

Evolution and heat transfer after droplet impact on heated liquid film with vapor bubbles inside

Experimental study of two-phase heat transfer of droplet impact on liquid film

Thin liquid film flow and heat transfer under spray impingement

Impact and boiling characteristics of a droplet on heated surfaces: A 3D lattice Boltzmann study

Dynamic characteristics of droplet impact on heated surfaces near Leidenfrost temperature

Interfacial phenomena and heat transfer associated with multi-droplet impact on flowing liquid film

Numerical investigation of droplet impact on heated surfaces with pillars

Droplet Evaporation to Boiling in Van Der Waals Fluid

Vaporization dynamics of a super-heated water-in-oil droplet: modeling and numerical solution

Dynamic Behavior of Droplet Impact on Laminar Superheated Particles

Coupling droplets/bubbles with a liquid film for enhancing phase-change heat transfer

Liquid film flow boiling heat transfer on cylinder for successive droplets impact

Droplet Impact on Superheated Micro-Structured Surfaces

About the 3D simulation of the boiling of liquid films and spray droplets during their contact with hot substrates

Numerical Investigation of the Flow Dynamics and Evaporative Cooling of Water Droplets Impinging Onto Heated Surfaces: an Effective Approach to Identify Spray Cooling Mechanisms

Numerical investigation of Weber number and gravity effects on fluid flow and heat transfer of successive droplets impacting liquid film

N ov 2 01 1 Drop impact on superheated surfaces

Simulation of Mass and Heat Transfer of Droplets Collision in a Flash Evaporation Pattern

Reduced residence time of droplet impact on heated surfaces

Splashing Morphology And Crown Dynamics Of Single Droplets Impinging Heated Liquid Films

Experiment on local convective heat transfer for successive droplets impacting on heated cylindrical surface