Methodology to compute spray cooling in the nucleate boiling regime

Nilojendu Banerjee,Cameron Tropea,Satyanarayanan Seshadri

DOI: https://doi.org/10.1016/j.ijheatmasstransfer.2024.125375

IF: 5.2

2024-03-21

International Journal of Heat and Mass Transfer

Abstract:This study introduces a methodology to compute spray cooling in the nucleate boiling regime. It examines the cooling of a horizontal circular tube, although the approach is not restricted to this geometry. While numerous investigations have considered nucleate boiling in the past, these are usually restricted to spray impingement onto a flat plate and not onto more complex surfaces. Furthermore, most prior studies are highly empirical in nature. The present study circumvents both of these restrictions. On the one hand, with more complex surfaces additional factors must be considered, in particular the influence of the local impingement angle on the number flux of impinging drops. On the other hand, the heat transfer for single droplets is first computed using existing theoretical solutions and then the principle of superposition is used to compute the global heat transfer from the surface over which the spray impinges. Accompanying this computation, a drop size distribution is specified in order to also investigate the influence of not only one representative drop size, but also the variance of drop size distribution on the heat transfer, an influence seldom reported on. Furthermore, the probability of drop-drop interaction on the surface has been estimated and the heat transfer correspondingly adjusted. This approach of computing total net heat transfer on a surface is first validated using available measurements in which the heat transfer in the nucleate boiling regime from a flat plate were used for comparison. The heat transfer from a circular tube was then computed as a function of mass flow rate, drop size distribution (expectation and variance) and wall temperature. Conditions for maximum heat transfer, corresponding to the critical heat flux, were identified. In all cases the net heat transfer was limited by the onset of drop-drop interaction on the substrate, i.e. the net coverage of liquid on the surface. The results of these parametric studies indicate clearly how the mass flow rate can be adjusted to maximize heat transfer while avoiding excess fluid consumption. Furthermore, the Sauter mean diameter is shown to be an appropriate drop size to use, if no further information is available concerning the size distribution.

engineering, mechanical,thermodynamics,mechanics