Abstract:FeTi‐Cu composites with varying Cu contents are subjected to high‐pressure torsion, and their deformation behavior is explored systematically using scanning electron microscopy, microhardness, and nanoindentation. The study identifies the limiting factors influencing the refinement during severe plastic deformation. The pronounced strength differences between phases lead to fragmentation primarily through hard‐hard (FeTi‐FeTi) contact points, promoted by homogeneous, i.e., non‐localized, and possibly turbulent material flow. These conditions are prevalent in Cu‐rich composites and during high‐temperature deformation. Conversely, Cu‐lean composites exhibit deformation localization, hindering the fragmentation process. Abrasion becomes an efficient refinement mechanism at the submicron‐/nano‐scale, particularly for composites containing higher concentrations of nanocrystalline FeTi and exhibiting homogeneous plastic deformation. Consequently, deformation localization in Cu‐lean composites inhibits both refinement mechanisms, while Cu‐rich compositions and higher temperatures result in efficient refinement but at the risk of coarsening at the nano‐scale. Refinement is localization‐limited in the former case and abrasion‐limited in the latter. Optimized processing conditions can overcome these constraints, yielding a uniform nanocomposite. This study sheds light on the intricate interplay of the mechanical properties of the respective phases in a composite, emphasizing the importance of tailored compositions and deformation conditions to optimize nanocomposites, particularly when dealing with challenging material pairings. This article is protected by copyright. All rights reserved.

Micro-Mechanical Fracture Investigations on Grain Size Tailored Tungsten-Copper Nanocomposites

Long-term Ball Milling and Hot Pressing of In-Situ Nanoscale Tungsten Carbides Reinforced Copper Composite and Its Characterization

Nanostructured Diamond-Tic Composites with High Fracture Toughness

Numerical investigation of fracture behavior of nanostructured Cu with bimodal grain size distribution

Micromechanical simulation of fracture behavior of bimodal nanostructured metals

In situ observation of intergranular fracture propagation in nanocrystalline freestanding ultrathin tungsten film

Exploring Refinement Characteristics in FeTi‐Cu x Composites: A Study of Localization and Abrasion Constraints

Deformation and Fracture Behavior of Electrocodeposited Alumina Nanoparticle/Copper Composite Films

Microstructure, mechanical behaviour and fracture of pure tungsten wire after different heat treatments

A comprehensive study on the damage tolerance of ultrafine-grained copper

Nano-Indentation Properties of Tungsten Carbide-Cobalt Composites as a Function of Tungsten Carbide Crystal Orientation

On nanostructured molybdenum-copper composites produced by high pressure torsion

Temperature dependent tensile and fracture behaviors of Mo-10 wt.% Cu composite

Microstructural and texture evolution of copper-(chromium, molybdenum, tungsten) composites deformed by high-pressure-torsion

Insight into the Microstructure and Tensile Behavior of the W–Cu Composite Reinforced with Tungsten Fibers and Particulates

Influence of TiC particle size on microstructural evolution and fracture mechanism of TiC/Al-Cu composites

High Strain and Strain-Rate Behaviour of PTFE/Aluminium/Tungsten Mixtures

Role of the microstructure and the residual strains on the mechanical properties of cast tungsten carbide produced by different methods

Effect of Microstructure Refinement on Surface Morphology and Dynamic Mechanical Properties of W-Cu Alloys

Fracture behavior in micro-cantilever beam and tension tests for Mg/CNT composites synthesized by the sandwich technique

Fracture Behavior of Cu/Cu–WCP Layered Composites