Abstract:The paper presents an experimental program on a structural system, consisting of three long-span portal frames. The primary structural members, including columns and rafters, were constructed using cold-rolled aluminium back-to-back built-up channel sections. The system configuration featured two bays of single-span cold-rolled aluminium portal frames connected in parallel by a series of purlins spanning between the rafters to create a free-standing structure. A total of three full-scale tests (Frame Tests 1,2 & 3) were conducted with two loading scenarios. Frame Tests 1&2, which were identical to ensure accuracy, were subjected to vertical loads only, while Frame Test 3 underwent testing with combined horizontal and vertical loads. In all the tests, the columns were unbraced. The main objectives of this paper are, first, to describe the test setups and observe the structural behaviours of the portal frame systems. Consequently, the ultimate capacities were determined, and the predominant failure modes of the portal systems were identified as flexural-torsional buckling of the unbraced columns. The paper also provides information on the mechanical properties of the aluminium alloy 5052-H36 materials used to fabricate the structural members and frame components, obtained from compressive and tensile coupon tests. Further, the elastic buckling loads of the columns in the frame systems are reported in this paper, as determined from the measured load-deformation curves. While this paper primarily delves into the behaviour of the cold-rolled aluminium portal frames with a focus on flexural torsional buckling failures of unbraced columns, the authors have also conducted a separate study on the same system. In that separate study, the portal frames with the columns predominantly restrained against flexural-torsional buckling were investigated to enhance the ultimate capacities of the portal frame systems.

Behaviour of bolted end-plate portal frame joints

Component Modeling of Steel Bolted End-Plate Joints under Bending and Shearing Loads

Experimental Research on Seismic Behavior of Reinforced Concrete Column-to-Steel Beam Joints with Bolted End-plate

Seismic Behavior of Exterior Connections with Steel Beams Bolted to Cft Columns

Experimental Evaluation of Steel Beam Bolted to Reinforced Concrete Column Connections

Bolted End Plate Connections for Steel Reinforced Concrete Composite Structures

Effect of Shear Deformation in Latticed Columns on Buckling of Heavily Loaded Industrial Portal Frames

Experimental Study on Reduced I-beam to CFRST Column Joints under Cyclic Loading

EXPERIMENTAL RESEARCH AND FINITE ELEMENT ANALYSIS ON A WELDED JOINT WITH TUBES INTERSECTED AT TWO DIFFERENT POINTS

Experimental investigation of long-span cold-rolled aluminium built-up section portal frames: Unbraced columns and flexural-torsional buckling

Moment Capacity of Bolted-Side Plate for the Eaves Joint of Nested Tapered Box Beam Portal Frame

Nonlinear FE Analysis on Stiffness and Resistance of Bolted Cold-Formed Steel Built-Up Joints

Finite Element Analysis and Tests on Bolted End-Plate Connections in Steel Portal Frames

Behaviour of Bolted End-Plate Connections to Concrete-Filled Steel Columns

Study of the Mechanical Properties of Beam-Column Joints in a New Type of Aluminum Alloy Portal Frame

Analysis of bolted moment connections in cold-formed steel beam–column sub-frames

Experimental study of end-plate joints with box columns

Experimental and numerical studies of a new prefabricated steel frame joint without field-welding: Design and static performance

Behaviour of flush end plate joints to concrete-filled steel tubular columns

Experimental study of end-plate connections between box-section columns and Ⅰ-section beams

Experimental and Numerical Study on Cyclic Behaviour of Steel Beam-to-column Joints