Abstract:Large-displacement shear appears between pile shaft and its surrounding soil during the penetration process, and cyclic shear is the typical feature in subsequent service load condition. In this paper, a series of interface shear tests have been conducted to investigate the sand-steel interface behaviors under large-displacement and cyclic shear. Three types of particles (quartz sand, carbonate sand and steel bead) and two normal boundary conditions (constant normal load, CNL; constant normal stiffness, CNS) were used in these tests. To simulate the large displacement shear process for monotonic installed pile, the large-displacement shear is performed using monotonic shear method. It is found that under the large-displacement shear with CNL condition, the quartz sand and carbonate sand show different breakage degrees and modes. Obvious particle breakage changes both the particle gradation and sample densification, which are the main reasons for the increase of interface friction angle. While for the cyclic shear with CNS condition, the interface strength shows a quick degradation feature, which is mainly affected by the initial shape of particles. It is also found that the previous interface shear plays a key role in this kind of degradation. When the shear displacement is small, the degradation is promoted with only a small amount of sand breakage. But if the sand breakage is significant under the large-displacement shear, abundant broken fine particles fill into the void and make the sand sample much denser. So, the degradation trend of interface strength will be suppressed. It is suggested that the previous large-displacement shear process for displacement pile should be adequately considered in the design.

Peak Friction Behavior of Smooth Geomembrane-Particle Interfaces

Sand Grain Crushing and Interface Shearing During Displacement Pile Installation in Sand

Microscale geomembrane-granular material interactions

Geomembrane Coefficients of Interface Friction

Shear behaviors and peak friction angle predictions of three critical geomembrane–soil interfaces

The Influence of Particle Elongations on Direct Shear Behaviour of Granular Materials Using DEM

Effects of Pore Fluid and Surface Roughness on Geomembrane - Soil Interface Behavior

Strength Characteristics of a Smooth HDPE Geomembrane/Nonwoven Geotextile Interface Based on a Novel Ring Shear Apparatus

Microscale Study of Geomembrane-Geotextile Interactions

Microanalysis of smooth Geomembrane–Sand interface using FDM–DEM coupling simulation

Effect of Young’s Modulus and Surface Roughness on the Inter-Particle Friction of Granular Materials

Shear strength of geomembrane–soil interface under unsaturated conditions

Effect of particle size on the anisotropic shear behavior of sand-textured geomembrane interface

Change pattern of geomembrane surface roughness for geotextile/textured geomembrane interfaces

Influence of micro and macroroughness of geomembrane surfaces on soil-geomembrane and geotextile-geomembrane interface strength

Dynamic Shear Behavior of Interface for Clay Reinforced with Geogrid Encapsulated in Thin Layers of Sand

Sand-Steel Interface Behaviour Under Large-Displacement And Cyclic Shear

Particle size effects on coarse soil-geogrid interface response in cyclic and post-cyclic direct shear tests

Interface Shear Strength of Liners with Geocomposite

Effect of cyclic shearing on contact surfaces of geo-materials under constant normal force

Shear characteristics of interface based on subloading-friction model