Abstract:In three different examples, the effects of the oxidation behaviour as well as the microstructural stability of high temperature materials and protective coatings was determined by combining the results of kinetic studies with extensive analytical investigations using, among other techniques, SNMS, SIMS, SEM, TEM, Rutherford back scattering (RBS) as well as X-ray diffraction. 1). The effect of water vapour on the oxidation behaviour of 9% Cr steels in simulated combustion gases has been determined. The effects of O2 and H2O content on the oxidation behaviour of 9% Cr steel in the temperature range 600-800 degrees C showed that in dry oxygen a protective scale was formed with an oxidation rate controlled by diffusion in the protective scale. In the presence of water vapour, after an incubation period, the scales became non-protective as a result of a change in the oxidation limiting process. The destruction of the protective scale by water vapour does not only depend on H2O content but also on the H2O/O2-ratio. 2). The increase of component surface temperature in modern gas turbines leads to an enhanced oxidation attack of the blade coating. Improvements in corrosion resistance and longer lifetime thermal barrier coatings in gas turbines have been achieved by improvement of the high temperature properties of MCrAlY coatings by additions of minor alloying elements such as yttrium, silicon and titanium. 3). The use of oxide dispersion strengthened (ODS) alloys provides excellent creep resistance up to much higher temperatures than can be achieved with conventional wrought or cast alloys in combination with suitable high temperature oxidation/corrosion resistance. Investigation of the growth mechanisms of protective chromia and alumina scales were examined by a two-stage oxidation method with 18O tracer. The distribution of the oxygen isotopes in the oxide scale was determined by SIMS and SNMS. The results show the positive influence of a Y2O3 dispersion on the oxidation resistance of the ODS alloys and its effect on growth mechanisms.

Characteristics of oxide films on TA16 alloy after long-term exposure in simulated secondary circuit water environment of small modular reactor

Effect of Oxidation Time on the Structure and Properties of Ti-25Nb-3Zr-2Sn-3Mo Titanium Alloy Microarc Oxide Film Layer

Surface Characterization of Thermally Oxidized Titanium Alloys

Characterization of oxides formed on iron-chromium-aluminum alloy in simulated light water reactor environments

Influence of composition and temperature on oxide film formation for Fe-Cr-Ni alloys in simulated PWR primary water

Early corrosion properties of titanium alloys, Ni-based alloys and stainless steel in supercritical water oxidation of sewage sludge

A high-resolution characterization of surface film formed on alloys 800 and 690 exposed to chloride and thiosulfate-containing solution at 300°C

Understanding the surface oxide evolution of T91 ferritic-martensitic steel in supercritical water through advanced characterization

Corrosion behavior of nickel base alloys, stainless steel and titanium alloy in supercritical water containing chloride, phosphate and oxygen

Characterization of the oxide film formed on alumina-forming austenitic stainless steel in deaerated, DH, DO, and OT supercritical water

The mechanism of oxide film formation on Alloy 690 in oxygenated high temperature water

Corrosion characteristics of Fe, Ni and Ti based alloys near the critical point of water and during supercritical water gasification and oxidation of municipal sludge

Investigation of Oxide Layer Development of X6CrNiNb18-10 Stainless Steel Exposed to High-Temperature Water

Failure behavior analysis of oxide film formed on super-heater tubes of boiler during deep peak process

Corrosion Mechanism and Electrochemical Reactions on Alloy 690 in Simulated Primary Coolant of Water–Water Energy Reactors

The Effect of Molten Phosphate on Corrosion of 316 Stainless Steel, Alloy 625, and Titanium TA8 in Supercritical Water Oxidation Conditions

Effect of Tensile Stress on the Oxide Properties of a Nickel-Based Alloy 600 in Simulated PWR Secondary Water

Oxidation behaviour and microstructural stability of alloy 625 during long-term exposure in steam

Analysis of corrosion layers on protective coatings and high temperature materials in simulated service environments of modern power plants using SNMS, SIMS, SEM, TEM, RBS and X-ray diffraction studies

Comparison and mechanism research of corrosion behavior of materials used in supercritical water-cooled reactors

XPS study of Ni‐base alloys oxide films formed in primary conditions of pressurized water reactor