Abstract:This paper proposes a new type of fabricated shear wall system, that is, the two ends of the horizontally distributed ribs and the top of the vertical distributed ribs are reliably connected with the cast-in-situ belt, and the bottom of the vertical distributed ribs is not penetrated and only connected by mortar. To study the seismic performance of the new wall, 7 specimens of the shear wall were designed and manufactured, including 2 cast-in-place shear walls and 5 new fabricated shear walls. Through low-cycle reciprocating loading tests, different analyses were made. Shear span ratio and different edge restraint structure of the new fabricated shear wall failure mode, bearing capacity and other seismic performance, and through OpenSees finite element analysis of the wall to verify the correctness of the modelling method. The test results show that the failure characteristics of the new wall are mainly the cracking and penetration of the mortar layer, the crushing of the corner concrete and the local buckling of the steel bars at the bottom of the edge members; compared with the cast-in-place wall, the new wall has the lower bearing capacity, but the deformation and energy consumption are not much different. The reinforced edge members can effectively compensate for the weakening of the integrity of the wall panel caused by the discontinuity of vertical steel bars. Among the 7 specimens, the overall performance of the wall with increased longitudinal reinforcement ratio is the best. The error between the wall finite element results and the test results is less than 5%, which shows that the modelling method in this paper has sufficient accuracy for the evaluation of the seismic performance of the new wall. In general, the new prefabricated shear wall system is feasible in high-rise buildings.

Reversed cyclic testing of high-capacity light wood frame shear walls with two and three rows of nails

Experimental Studies of Light-Weight Woodframe Shear Walls with Ply-Bamboo Sheathing Panels

Seismic Behavior of Composite Shear Walls Incorporating Concrete-Filled Steel and FRP Tubes As Boundary Elements

Lateral Loading Performance of Lightweight Glubam Shear Walls

Monotonic and cyclic tests of round bamboo shear walls

Lightweight Woodframe Shear Walls with Ply-Bamboo Sheathings

LATERAL RESISTANCE OF LIGHTWEIGHT WOOD AND BAMBOO SHEAR WALLS

Seismic Behavior of Cold-Formed Steel Frame Shear Walls Sheathed with Ply-Bamboo Panels

Experimental study and numerical simulation of seismic performance of stiffened thin steel plate shear walls considering the effect of vertical load on frame column

Lateral Force Resistance Performance of Sheathing Sandwiched Wood Shear Walls

Experimental Investigation of Laterally Loaded Double-Shear-nail Connections Used in Midply Wood Shear Walls

Lateral shear performance of sheathed post-and-beam wooden structures with small panels

High-strength cold-formed steel framed shear wall with steel sheet sheathing

Lateral performance of cold-formed steel framed shear walls using slitted sheathing with stiffeners

Seismic behavior of multi-story structural walls under cyclic lateral loading: Experimental study

Test study for the performance of wood-cold-formed steel frame shear walls with difference detailed configurations

Seismic behavior of composite shear walls incorporating high-strength materials and CFST boundary elements

Experimental Study of Shear-Critical Reinforced-Concrete Shear Walls under Tension-Bending Shear-Combined Cyclic Load

Studies of Nail Connectors Used in Wood Frame Shear Walls with Ply-Bamboo Sheathing Panels

Predicting the lateral performance of a new type of Midply shear wall system: An efficient methodology

Experimental study on seismic performance of new-type fabricated shear wall with mortar connection