Abstract:<p>For a heat treatment furnace, the precise study of the flow characteristics, combustion and heat transfer in the furnace is essential to know the temperature distribution in a slab during the heating process. In this context several different three-dimensional CFD (Computational Fluid Dynamics) models have been developed to simulate the combustion and heat transfer process in the furnace. These models were developed based on direct fired reheating furnaces with continuous fuel input. In this paper, a novel three-dimensional transient CFD model used to investigate the slab heating characteristics in the heat treatment furnace with pulse combustion was developed. The transient calculation in the furnace was performed based on the steady-state simulation of the furnace temperature, and the movement of slabs on the rollers in the furnace was simulated using dynamic mesh. By comparison, the results from the EDC with two different reaction mechanisms showed good consistency. However, the EDC with the two-step reaction mechanism required one fifth the calculation time of the EDC with the GRI-Mech3.0, and was thus the preferred model. In contrast to direct fired reheating furnaces, the outer radiant tube walls were treated as the coupled boundary conditions in the model to realize indirect heat transfer between the process gas in the furnace and the combustion gas in the radiant tubes. Furthermore, a pulse combustion method was proposed to control the working states of the burners based on UDF (User-Defined Function), in order to realize the pulse combustion process in the heat treatment furnace. By the validation of "Black Box", the temperature variation of the slab and the gas temperature in the furnace predicted by the model agreed well with the experimental results. The simulation revealed that the temperature distribution of the radiant tubes and furnace gas was uniform and the maximum temperature difference on the outer radiant tube walls was less than 84 K. During the slab transient heating process, the slab temperature distribution became more uniform in the soaking zone and the maximum temperature difference along the thickness of the slab was below 13 K at discharge.</p>

Analysis of heat transfer coefficient and skid marks in a slab reheating furnace considering beam misalignment and contact heat conduction

Analysis of billet temperature non-uniformity in a regenerative reheating furnace: Considering periodic combustion switching and misalignment contact of walking beams

Study on Billet Temperature Prediction and Furnace Temperature Optimal Setting of Regenerative Reheating Furnace

Theoretical Studies on the Water-colded Black Mark of Steel Slab in a Walking Beam Type Reheating Furnace

Modeling approach and numerical analysis of a roller-hearth reheating furnace with radiant tubes and heating process optimization

Numerical analysis of the heat transfer of radiant tubes and the slab heating characteristics in an industrial heat treatment furnace with pulse combustion

Experimental Investigation of the Scaling-Off Location and the Slag Mass in Pulverized Coal-Fired Boiler with Water-Cooled Slag Removal

Modeling effects of swirl burners on the heating quality of slabs and flame morphology in a walking-beam reheating furnace

Thermo-Mechanical Coupling Computation and Warping Analysis During Controlled-Cooling of X65 Heavy Pipeline-Plate

Performance of fuel-air combustion in a reheating furnace at different flowrate and inlet conditions

Investigation of Solidification Heat Transfer in Slab Continuous Casting Process Based on Different Roll Contact Calculation Methods

The Modeling and Control of a Reheating Furnace.

Advanced Control Of Walking-Beam Reheating Furnace

Investigation on non-uniform friction behaviors of slab during continuous casting based on an inverse algorithm

FAILURE ANALYSIS OF SKID PIPE LEAKS IN WALKING BEAM TYPE REHEATING FURNACE APPLICATIONS

Temperature Field Simulation and Experimental Analysis of Laser Cladding 45 Steel.

Finite element analysis and experiment on induction heating process of slab continuous casting-direct rolling

Mathematical Heat Transfer Model Research for the Improvement of Continuous Casting Slab Temperature

Numerical investigation on heating process of Ti/Steel composite plate in a walking-beam reheating furnace

Optimization of Temperature Distribution in Thick Slab Continuous Casting for Direct Hot Rolling

Analysis of heat transfer and thermal stress in continuous casting with mechanical reduction