Abstract:Eight optimization compensated parameters of the reconfigurable topology are obtained from the Pareto front to achieve the required constant current and constant voltage charging outputs. By switching the compensated capacitors, the selected parameters can make the current and voltage fluctuation less than 9.3% and 7.9%, respectively, during the coupling charging range from 0.3 to 0.22. At present, most of the analyses or studies about inductive power transfer (IPT) with constant current (CC) output and constant voltage (CV) output are carried out without considering misalignment conditions or different gaps. An IPT system satisfying battery charging demand and anti‐misalignment requirements simultaneously is infrequent. This paper proposes a multi‐objective particle swarm optimization method of IPT reconfigurable topology to realize CC and CV modes at varying resistance conditions and wide coupling ranges. The output characteristics of an inductor–capacitor–capacitor (LCC)–LCC compensation circuit have been explored, and it is found that the secondary‐side compensated capacitors have a greater impact on the output power, which can be used to improve power regulation ability accompanied by coupling varying. Eight optimization compensated parameters of the reconfigurable topology are obtained from the Pareto front to achieve the required CC and CV charging outputs. By switching the compensated capacitors, the selected parameters can make the current and voltage fluctuation less than 9.3% and 7.9%, respectively, during the coupling charging range from 0.3 to 0.22. Moreover, primary zero voltage switching operation is achieved to enable high efficiency. The simulation and the experimental verification are carried out to verify the validity of the proposed method.

3-D Misalignment Tolerant E-scooter IPT System with Hybrid Control Based on Three-coil Design for Load-independent CC/CV Outputs

An Inductive Power Transfer Charging System With a Multiband Frequency Tracking Control for Misalignment Tolerance

A Hybrid IPT System Implementing Misalignment Tolerance and Constant Current Output with Primary Intermediate Coil

An Integrated Inductive Power Transfer System Design with a Variable Inductor for Misalignment Tolerance and Battery Charging Applications

A Hybrid IPT System with High-Misalignment Tolerance and Inherent CC–CV Output Characteristics for EVs Charging Applications

An Inductive Power Transfer System Design with Large Misalignment Tolerance for EV Charging.

A Dual-Source Inductive Power Transfer System Optimized with Large Misalignment Tolerance

Multiple Coils IPT System Implementing CV Output Characteristics with Improved Misalignment Tolerance

Analysis and Design of an IPT System Based on Shunt Inductor Compensation for Battery Charging Applications.

Design of an Inductive Power Transfer System with Constant Current and Constant Voltage Outputs Based on Multi-frequency Circuit

Minimizing Current in Inductive Power Transfer Systems With an Asymmetrical Factor for Misalignment Tolerance and Wide Load Range

Constant-Voltage and Constant-Current Controls of the Inductive Power Transfer System for Electric Vehicles Based on Full-Bridge Synchronous Rectification

An Integrated Mutually Compensatory Dual Receiver for AGV Misalignment-Tolerant IPT Charging

Novel IPT system for enhanced efficiency and anti-misalignment capability

A Misalignment-Tolerant Hybrid Coupler for Electric Vehicle IPT Charging Systems.

An IPT System with Constant Current and Constant Voltage Output Features for EV Charging

A Control Strategy for Achieving Constant Voltage Output with an Extensive ZVS Operating Range in Bidirectional Wireless EV Charging Systems

Research on a Three-Coil Hybrid IPT Charger with Improved Tolerance to Coupling Variation and Load-Independent Output

A Hybrid Three-Coil IPT Topology with High Tolerance to Pad Misalignment for Battery Charging Applications

A Reconfigurable IPT System With CC‐CV Output Characteristics and High Misalignment Tolerance

Multi‐objective optimization of inductive power transfer system with reconfigurable topology for misalignment tolerance