Diffusion in titanium and titanium—niobium alloys

G. B. Gibbs,D. Graham,D. H. Tomlin
DOI: https://doi.org/10.1080/14786436308207292
1963-08-01
Abstract:Earlier work in this laboratory on tracer diffusion of solutes in βTi, which resulted in abnormally low values of activation energy and frequency factor, has been extended to higher temperatures. Diffusion coefficients for the solutes Nb, Mo, Cr, Mn, Fe, Co and Ni have been measured over the whole available temperature range from the α—β transformation point at 900°C to the melting point of Ti, 1650°C. The resulting Arrhenius plots show curvature in the direction of apparent activation energies and frequency factors increasing with temperature. This is of special interest in view of the abnormalities previously found, and possible interpretations are suggested. It has not proved possible to distinguish conclusively between two important possibilities, the presence of two diffusion mechanisms, or a single mechanism with temperature dependent parameters. Structure sensitive diffusion mechanisms are believed not to account for the observed curvature. Isotope effect experiments with 55Fe and 59Fe appear to exclude the 4-atom ring diffusion mechanism as a possible basis for explaining the abnormally low activation energies and frequency factors. Experiments on the diffusion of Nb in Ti—Nb alloys have been extended to the whole composition range 0 to 100% Nb, and the activation energy and frequency factor are given as functions of composition. Further work at the Ti-rich end of this system is necessary to resolve certain ambiguities.
materials science, multidisciplinary,physics, applied, condensed matter,metallurgy & metallurgical engineering
What problem does this paper attempt to address?