Abstract:Nowadays, due to the growing demands of data centers, the traditional line frequency transformer based data center power distribution system (DC-PDS) is becoming bulky and inefficient. Although SST-based DC-PDS dramatically improves the system efficiency, the traditional multicell SST with input-series output-parallel architectures has limitations. Using high-voltage devices to develop single-cell SST improves system performance, however, its application is limited by high-voltage power devices. As an alternative solution, achieving high blocking voltage through the series connection of low-voltage devices brings several advantages. Nevertheless, the series connection brings about two main problems, namely the voltage imbalance among devices and the increment of switching loss. This article proposes a medium voltage series resonant converter (MVSRC) with series-connected SiC MOSFETs. By adding snubber capacitor to each SiC MOSFET and working at LLC resonant soft-switching mode, the voltage imbalance is reduced and switching loss is decreased. Due to snubber capacitors, there are differences between MVSRC and traditional LLC converter, hence the analytical model of MVSRC is established. Moreover, the voltage imbalance model is established and the voltage imbalance sensitivity is defined to guide the snubber parameter selections. Then, a design example of the 99% efficient 5-kV/400-V prototype is presented. Last, the experimental results show that the voltage imbalance is reduced effectively and the switching loss is decreased dramatically, verifying the validity of proposed methods and the accuracy of analysis.

Neutral-Point Voltage Balancing Methods of Series-Half-Bridge LLC Converter for Solid State Transformer

A Five-level AC/DC Converter for MV Solid-State Transformer

Research on Voltage and Power Balance Control for Cascaded Modular Solid-State Transformer

Quasi-Two-Level Bridgeless PFC Rectifier for Cascaded Unidirectional Solid State Transformer

Series-Connected Power Devices in a CLLC Resonant Converter for DC Transformer Applications

A Proposed Neutral-Point Voltage Balancing Method for Three-Phase Three-Level T-type Inverter under Non-Unity Power Factor

A Neutral-Point Potential Balancing Control Method with Third Harmonic Injected Pulse Width Modulation for Three-Level Converters

A Neutral-Point Voltage Balancing Algorithm for Six-phase H-Bridge Neutral-Point-Clamped Converter

Common Mode Voltage Reduction and Neutral-Point Voltage Balance for Quasi-Z-Source Three-Level Neutral-Point-Clamped Inverters

Voltage Balancing Method for Series-Connected SiC MOSFETs under No Load Condition

Three-Phase Seven-level H-bridge Commutated Active Clamped Converter

A novel three-phase seven-level active clamped converter using H-bridge as a level doubling network

Capacitor Voltage Balancing Control for a Novel 5-Level Dual Active Bridge Converter

Voltage-Balancing Strategy for Three-Level Neutral-Point-Clamped Cascade Converter under Sequence Smooth Modulation

Medium Voltage Soft-Switching DC/DC Converter with Series-Connected SiC MOSFETs

Neutral-Point Potential Balancing of a Five-Level Active Neutral-Point-Clamped Inverter.

Common High-Frequency Bus Based Cascaded Multilevel Solid-State Transformer With Ripple and Unbalance Power Decoupling Channel

Quasi Two-Level Operation and Neutral-Point Voltage Balance Method for a Four-Level ANPC Based Dual Active Bridge DC-DC Converter

Partial Fluctuation Power Control of Resonant Converter in Solid-State Transformer

DC Bus Balancing Control Techniques for the Cascaded Neutral Point Clamped Modular Converter