Abstract:Capacitor voltage balancing is a critical issue for neutral-point-clamped-based converters, including the two/three-level dual-active-bridge dc–dc converters. The unbalanced capacitor voltage will increase the voltage stress on power devices and negatively affect the reliability of the converters. Two typical problems during the capacitor voltage balancing process should be solved, i.e., power fluctuation minimization and determination of the transformer current polarity. Accordingly, this article proposes a balancing control scheme based on the complementary switching-state (CSS) method. In the CSS method, the switching states, which are identified to be adverse for balancing, will be replaced by their corresponding CSSs to control the neutral-point current while keeping the voltage and current waveforms unchanged. By doing so, the power fluctuation and current overshoot during the balancing process can be significantly reduced. Moreover, since the dynamic voltage and current waveforms are identical to the steady-state waveforms, the transformer current polarity during the balancing process can be identified based on the steady-state power and current models. Therefore, the determination of the transformer current polarity can be simplified compared to the traditional balancing control scheme. Finally, experimental results are carried out to verify the performance of the proposed balancing control scheme.

Quasi Two-Level Operation and Neutral-Point Voltage Balance Method for a Four-Level ANPC Based Dual Active Bridge DC-DC Converter

Structural Design of A Five-Level Hybrid Active Npc Converter for High Power Density Motor Drives

Capacitor Voltage Balancing for Multi-Level Dual-Active-Bridge DC-DC Converters

Capacitor Voltage Balancing Control for a Novel 5-Level Dual Active Bridge Converter

Hybrid-Bridge-Based Dual-Active-Bridge Converter With an Asymmetric Active-Neutral-Point-Clamped Three-Level Bridge

A SiC & Si Hybrid Four-Level ANPC Converter with Multi-Step Soft-Switching Modulation Achieving Capacitor Voltage Balancing

A Novel Single-Stage Five-Level Common-Ground-Boost-Type Active Neutral-Point-Clamped (5L-CGBT-ANPC) Inverter

Modulation and Voltage Balance Control of a Four-Level ANPC H-Bridge Converter for Ship Medium-Voltage Propulsion Systems

Active Selection of Current Commutation Loop for Hybrid Three-Level Dual Active Bridge DC-DC Converter with TPS Control

Modulation and Soft-Switching Optimization Control of Multilevel Dual Active Bridge DC-DC Converters

A neutral-point potential balancing algorithm for five-level ANPC converters

Three-Phase Seven-level H-bridge Commutated Active Clamped Converter

A novel three-phase seven-level active clamped converter using H-bridge as a level doubling network

Topology and Control of a Four-Level ANPC Inverter

Neutral-Point Potential Balancing of a Five-Level Active Neutral-Point-Clamped Inverter.

Modeling and Analysis of 2/3-Level Dual-Active-Bridge DC-DC Converters with the Five-Level Control Scheme

Common Mode Voltage Reduction and Neutral-Point Voltage Balance for Quasi-Z-Source Three-Level Neutral-Point-Clamped Inverters

Loss Distribution Analysis of Three-Level Active Neutral-Point-Clamped (3L-Anpc) Converter with Different Pwm Strategies

Optimized Switching Strategy for ANPC–DAB Converter Through Multiple Zero States

Full-Power-Range Multi-Objective Optimization Scheme for Three-Level ANPC-DAB-Based Distributed Generation System

Capacitor Voltage Balancing Control Scheme for 2/3-Level DAB Converters