Abstract:This paper reports the results of scratch tests on three rocks (Bonne Terre Dolomite, Alabama Marble and Dunnville Sandstone) conducted at depths of cut ranging from 0.2 mm to 2.6 mm. The experiments were performed on slabs of thickness slightly smaller than the cutter width, with a camera recording the entire cutting process. The test results reveal the existence of three cutting regimes: ductile, fragmentation, and brittle with increasing depth of cut. The regimes differ by the failure mode, the dependence of the specific energy ε on the depth of cut d, and the fragment shapes. In the ductile regime, ε∼d0 and the fragments are constitutive grains of the rock or powder as a result of intense shearing. In the fragmentation regime, ε∼d−1/2 and the fragments is a mix of ductile-type particles and flake-like chips also the product of shear failure. Finally, the brittle regime is characterized by ε∼d−1 and is essentially associated with chip-like fragments that come in two varieties depending on whether they are created by shear or by tension. The d−1-dependence of the specific energy can only be observed if the rock is sufficiently homogeneous at the scale of the experiment. The distinction between different modes of failure is based on evidence from video recording and fractography with a Scanning Electron Microscope. It is shown that the dominance of tensile over shear fracture is intimately related to the existence of a crushed zone, which acts as a wedge to initiate a tensile macrocrack in a compressive stress field. Finally, an analysis of the energy partitioning in the brittle regime indicates that the energy dissipated in creating new surfaces with a tensile crack is actually negligible compared to the energy expended in the formation of the wedge. This result indicates that the mode I toughness cannot be determined from the specific energy in the brittle regime, on the basis of a model of a crack parallel to the free surface, in contradiction with published claims to that effect. Finally, this experimental investigation clarifies some confusion in the literature, rooted on assuming the existence of only two modes of failure, ductile and brittle.

A multi-method investigation of the permeability structure of brittle fault zones with ductile precursors in crystalline rock

Experimental and Numerical Investigation on Shear Failure Behavior of Rock-like Samples Containing Multiple Non-Persistent Joints

Cracking Behavior and Acoustic Emission Characteristics of Rock Containing a Single Preexisting Flaw

Permeability partitioning through the brittle-to-ductile transition and its implications for supercritical geothermal reservoirs

Modeling Crack Propagation in Heterogeneous Granite Using Grain-Based Phase Field Method

Cracking Behavior and Acoustic Emission Characteristics of Heterogeneous Granite with Double Pre-Existing Filled Flaws and a Circular Hole under Uniaxial Compression: Insights from Grain-Based Discrete Element Method Modeling

Investigating rough single-fracture permeabilities with persistent homology

Discrete Element Modeling of Permeability Evolution During Progressive Failure of a Low-Permeable Rock Under Triaxial Compression

Investigating the Permeability Evolution of Artificial Rock During Ductile and Brittle Deformation Under Pressurized Flow

Failure mechanism of brittle rock with 3D parallel preset flaws based on the particle displacement trend method

Quantitative investigation of crack propagation and fracture mechanism of fissured granite from the mesoscopic perspective

Permeability Experiment of Fractured Rock with Rough Surfaces under Different Stress Conditions

Experimental study of the mechanical, energy conversion and frictional heating characteristics of locking sections

An experimental investigation of brittle failure mechanisms in scratch tests of rock

Brittle Damage Processes Around Equi‐Dimensional Pores or Cavities in Rocks: Implications for the Brittle‐Ductile Transition

Experimental Evaluation of Conjugate Flaws on Rock Dynamic Fracturing

Laboratory investigations on failure, energy and permeability evolution of fissured rock-like materials under seepage pressures

An experimental investigation of the fracturing behaviour of rock-like materials containing two V-shaped parallelogram flaws

Investigation on Pore Structure and Permeability of Concrete–Rock Interfacial Transition Zones Based on Fractal Theory

Crack propagation mechanism of rock-like specimens containing non-parallel flaws subjected to internal hydraulic pressure and shear loading

Investigation of Phyllite-based Brazilian tests and fracture failure patterns via AE and PFC3D