Abstract:The structural stability of engineering rock mass under dynamic disturbance is directly associated with the fracture mechanics properties in engineering practice. Fully understanding the rock’s fracture mechanical behavior and crack evolution caused by stress concentration at the crack tip in engineering rock mass under dynamic load can offer useful insight into the rock’s dynamic fracture mechanism. A dynamic test using split-Hopkinson pressure bar (SHPB) test system was performed on a single prefabricated fissure sandstone centrally cracked Brazilian disk (CCBD) specimens. Based on the theory of fracture mechanics and one-dimensional stress wave theory, the dynamic crack initiation criterion of CCBD specimen is proposed, and the regression model of sandstone’s dynamic fracture toughness under the coupling effect of fissure angle and strain rate is established by using response surface methodology (RSM). The influence of strain rate and fissure angle on stress wave characteristics, dynamic tensile mechanical behavior, and fracture mechanics characteristic was investigated in this study. The findings demonstrate that: (1) The fissure angle plays a pivotal role in determining the failure mode of sandstone. As the fissure angle increases, three distinct failure modes emerge in the sandstone specimens, while variations in strain rate have minimal impact on the fracture mode of these specimens. (2) Alterations in the fissure angle result in changes to the waveform of transmitted waves. When the fissure angle is below 30°, the transmitted wave exhibits “double peak” characteristics; when it exceeds 30°, a “single peak” waveform is observed. This phenomenon can be attributed to diffraction principles governing incident waves. (3) When the impact pressure is 0.2 MPa, the peak load initially exhibits an increase followed by a decrease, with the peak load reaching its maximum at a fracture angle of 60°; when the impact pressures are 0.3 and 0.5 MPa, there exists a negative correlation between the peak load and the fissure angle. (4) The influence of strain rate on sandstone’s fracture resistance is predominant, with alterations in fissure angle exerting an auxiliary effect on this property. The research results can provide a theoretical and experimental basis for dynamic disaster prevention in urban underground space.

Permeability Experiment of Fractured Rock with Rough Surfaces under Different Stress Conditions

Analysis of Damage and Permeability Evolution of Sandstone under Compression Deformation

Damage-Seepage Evolution Mechanism of Fractured Rock Masses Considering the Influence of Lateral Stress on Fracture Deformation Under Loading and Unloading Process

Experimental Study on Shear-Seepage Coupling Characteristics of Single Fractured Rock Mass Under Cyclic Loading and Unloading

Unloading-induced Permeability Recovery in Rock Fractures

Effects of cyclic fatigue loads on surface topography evolution and hydro-mechanical properties in natural and artificial fracture

Influence of Asperity Degradation and Gouge Formation on Flow During Rock Fracture Shearing

Study on Hydro-Mechanical Coupling Failure and Permeability Enhancement Mechanisms for Sandstone with T-Shaped Fractures

Experimental mechanical strength and deformation characteristics of deep damaged–fractured rock

Laboratory investigations on failure, energy and permeability evolution of fissured rock-like materials under seepage pressures

Experimental and Numerical Investigation of Permeability Evolution with Damage of Sandstone under Triaxial Compression

PERMEABILITY MEASURING OF LARGE SCALED SINGLE FRACTURED MEDIA WITH A SEEPAGE-STRESS COUPLING TESTING APPARATUS

Relating Hydro‐Mechanical and Elastodynamic Properties of Dynamically Stressed Tensile‐Fractured Rock in Relation to Applied Normal Stress, Fracture Aperture, and Contact Area

Experimental Study on Seepage Characteristics of a Soil-Rock Mixture in a Fault Zone

Experimental Study on Dynamic Tensile Mechanical Behavior and Fracture Mechanical Characteristics of Sandstone with a Single Prefabricated Fissure

Experimental Investigation of Pre-Flawed Rocks under Dynamic Loading: Insights from Fracturing Characteristics and Energy Evolution

Study on dynamic fracture behaviour and fracture toughness in rock-mortar interface under impact load

Study on the Mechanical and Permeability Evolution of a Composite Rock Mass in an Aquifuge Under Hydraulic Coupling

Dynamic Response and Damage Regularity of Sandstone with Different Moisture States under Cyclic Loading

Experimental investigation of pre-flawed rocks under combined static-dynamic loading: Mechanical responses and fracturing characteristics

Experimental investigation of fracture behavior of rock-like materials containing 3D embedded flaws subjected to direct and unloading normal stress shear action