Abstract:The as-laid embedment is a key design element of deep-water pipelines, as it significantly affects the longitudinal and transverse pipe-soil interaction and thermal insulation. Due to the small-amplitude oscillations driven by the sea state as well as lay vessel motions, the as-laid embedment is significantly greater than the predictions derived from static penetration analyses. This paper presents a numerical study into the cyclic embedment behavior of deep-water pipelines in soft clay using a recently developed sequential limit analysis (SLA) technique. It directly models the evolution of model geometry and material properties through a consecutive series of small displacement analyses and incorporates the effect of strain softening and strain rate on soil strength. A rigid plane-strain pipe section is pushed-in-place and then subjected to small-amplitude cyclic lateral displacements, with an accumulated lateral pipe displacement of up to 60 diameters. Careful comparisons between the numerical results with published centrifuge data are provided to demonstrate the robustness of SLA, in terms of pipe invert trajectory and soil resistance, followed by an extensive parametric study investigating the effect of strain rate, strain softening, oscillation amplitude, and loading history. More detailed aspects of the cyclic loading behavior are discussed with reference to soil failure mechanisms and bearing capacity yield envelopes. A strong correlation between accumulated lateral pipe displacement and pipe embedment is identified, regardless of the varying oscillation amplitudes, and soil buoyancy is found to play the most significant role in determining the final pipe embedment. The present study aims to assist the development of a macro-element plasticity pipe-soil model that can be incorporated into simplified three-dimensional (3D) pipeline-seabed models, as well as to promote the application of SLA to model complex large-displacement pipe-soil interaction problems.

Impact of bedding layers to soil-pipe-liner structure under static and traffic loads with EPR technology

Modeling Cyclic Embedment of Deep-Water Pipelines Using Large Displacement Limit Analysis

Elastic Buckling of Cylindrical Pipe Linings with Variable Thickness Encased in Rigid Host Pipes

Assessment Model of Pipe–soil Interaction During Large-Amplitude Lateral Displacements for Deep-Water Pipelines

Analytical Analysis of Pipeline–soil Interaction During J-lay on a Plastic Seabed with Bearing Resistance Proportional to Depth

Road Surface Permanent Deformations with a Shallowly Buried Steel-Reinforced High-Density Polyethylene Pipe under Cyclic Loading

Elastoplastic Pipe-Soil Interaction Analyses of Partially-Supported Jointed Water Mains

Dynamic Analyses of Pipes in Saturated Soil under Traffic Loads

Experimental and numerical simulation of formed-in-place pipe liner for repairing water mains with void

Physical and Analytical Modeling of Soil Loss Caused by a Defective Sewer Pipe with Different Defect Locations

Mechanistic-Empirical Model to Characterize Rutting in Unpaved Road with a Shallowly Buried SRHDPE Pipe

2-D element analysis of environmental effect caused by pipe jacking

An innovative solution for the dynamic response of buried pipelines in layered transversely isotropic soil under pavement structures

LRFD Approach to CFRP Renewal of Prestressed Concrete Cylinder Pipes

3D FEM ANALYSIS ON DEFORMATION OF PERPENDICULARLY CROSSING BURIED PIPELINE IN PIPE JACKING

Basalt‐polypropylene fiber reinforced concrete for durable and sustainable pipe production. Part 2: Numerical and parametric analysis

Consolidation effects on pipe-soil interaction due to tunneling

Modeling pipe-soil interaction under surface loading using material point method

Numerical Study of Resistance Loss and Erosive Wear during Pipe Transport of Paste Slurry

Modeling Pipe–Soil Interaction under Lateral Movement Using Material Point Method

Dynamic Response Analysis of Buried HDPE Pipes under Vibration Compaction Considering the Influence of Buried Depth and Filling Modulus