Abstract:The current rapid development of weak electrical installations has made the monitoring of weak signals increasingly important. For highly sophisticated instruments, the slightest signal deviation will cause terrible and irreparable damage. At present, commercially available multimeters generally have low accuracy, which does not meet the error range required for weak electrical signal monitoring, because it cannot be monitored in real-time, and requires manual handheld data collection. To address the above demands, this study designs and builds a voltage and current signal collector based on the STM32F103 microcontroller. In this case, the DC voltage is designed in the range of −5 V to 5 V, and for the current is from 4 to 20 mA, and the AC voltage from 0 to 5 V can be measured. The measurement results will be displayed on the LCD screen. The collector uses RS485 as the physical transmission interface and the communication protocol uses the Modbus-RTU protocol, which can work properly in the range of 10–24 V DC supply. The analysis of the corresponding requirements is followed by the circuit design to complete the transmission and display of the collected data. The DC voltage measurement part contains the process of boosting and dividing the circuit and then reading it, the current measurement is completed by an isotropic proportional amplifier circuit, and the AC voltage RMS measurement uses the AD637 true RMS conversion chip to realize the circuit, the design contains the software part, the hardware part, and the communication part design. The final device has been tested to meet the national standard of maximum permissible error range within ±0.1 and is suitable for the complex environment envisaged.

A design of CAN-bus based collector for Automatic Meter Reading system

Design and Implementation of a Wireless Automatic Meter Reading System

Application Of Soc Zigbee Technology In The Remote Reading Meter System

Multi-node data acquisition and analysis system for the development of AT electronic control unit.

Control System of Combine Harvester Threshing Cylinder Based on CAN Bus

Acquisition and Diagnosis Module for Vehicle Information Based on SAE J1939 Protocol

Automatic Measurement and Control System for Vehicle ECU Based on CAN Bus

Remote Automatic Meter Reading System.

Design of Single-Phase Intelligent Meter Based on RFID Semi Active Technology

Design of Handheld Meter Reading Terminal Based on UHF RFID

Application of CAN bus in development of mass spectrometer

Design of Multi-sensor Data Collection system based on wireless radio frequency technology

Design and implement of baseband circuits for a wireless automatic meter reading application

The BMS CAN Communication Design in 32-bit Microprocessor

Reversing radar system based on CAN bus

Application design of CAN bus in tractor test bench

A Design of Conversation System with CAN Bus

Weak Current Signal Detection Device Based on Embedded System

Design and analysis of a low power consumption multifunctional marine data collector

Wireless Electric Power Copy Ammeter and Insurance System Based on GPRS

On-line Monitoring Device in Substation Based on the Technology of CAN Bus and ARM Microprocessor