Abstract:A new scheme was adopted in the hardware-in-loop (HIL) simulation platform adopted to develop simulation ECU and monitor-control interface. Hardware design: The simulation ECU was developed with the 32-bit single chip MC68376 of MOTOROLA, which converted and sent all necessary parameters for electronically controlled diesel ECU (object ECU); An accurate measurement was achieved to actuator signals with no-contact current sensors. Software design: The high efficiency of assembly language and the convenience of c language were combined to realize simulation ECU control program; The multithread technology was used in PC control program, and there were 3 threads: a monitor-control interface thread, a diesel model thread and a communication thread. Labview was used to develop the monitor-control interface as main thread, and diesel model and communication threads were programmed by C+ and ran in the background as sub threads. Communication: CAN bus communication protocol was adopted and communication programs were developed separately for TouCAN module and USBCAN, communication data is converted with an USBCAN intelligent conversion card and an accurate, reliable and quick communication was achieved between simulation ECU and PC, with baud rate up to 500 kbit/s. This platform has been successfully used to develop HIL system for GD-1 high pressure common rail electronically controlled diesel engine and Delphi EUP (a little changed).

Automatic Measurement and Control System for Vehicle ECU Based on CAN Bus

Multi-node data acquisition and analysis system for the development of AT electronic control unit.

The Design of AMT communication module based on CAN bus

MULTIPLE ELECTRONIC CONTROL UNITS CALIBRATION SYSTEM BASED ON EXPLICIT CALIBRATION PROTOCOL AND J1939 PROTOCOL

Development of Calibration Platform for Gasoline Engine Management System Based on CAN Bus

Development of a New Calibration System for Electronic Control Units Based on CCP

Development and Implementation of Calibration System for ECU in Electronically-Controlled Diesel Engine

Design and Implementation of An On-board Measurement System based on CAN Bus

A Multi-ECU Calibration System for Hybrid Vehicle Based on XCP Protocol

Development of Engine Control Unit Monitoring and Calibration System Based on CCP

The Hardware Design of Hardware-in-Loop Simulation System of Diesel Engine High Pressure Common-Rail ECU Based on CAN Bus

AMT Control Quality Evaluation Test System Based on CANoe

Flexible CAN Bus Measurement Platform Based on Virtual Instrument Technology

Design and Application of CAN/LIN Gateway Controller in Automotive Body Network

The design of electric motor car's body network based on CAN-bus distributed control

Development of a New Hardware-in-loop Simulation Platform for GD-1 Diesel Engine Based on CAN and Multithread Technologies

Acquisition and Diagnosis Module for Vehicle Information Based on SAE J1939 Protocol

Design and Analysis of Multi-Node CAN Bus for Diesel Hybrid Electric Vehicle

Vehicle stability control test system applied on low friction road based on CAN technology

Digital Automobile Cluster Based on CAN BUS

Design of Communication System Based on Controller Area Network for EV Battery Management System