Abstract:This article presents a fully differential high-dynamic-range direct-conversion receiver for sub-1-GHz band applications in a 180-nm CMOS technology. The integrated self-adaptive multipart automatic gain control (AGC) loops are designed to cope with large input signal. In the radio frequency (RF) domain, a gain-adjustable noise-canceling balun low-noise amplifier (LNA) and a high-linearity RF variable gain amplifier (VGA) are co-designed to keep a steady differential output power for the mixer stage. In baseband (BB), a novel gain distribution method is proposed to protect BB circuits from saturation. To prove the concept, one of the most typical and strict application scenarios in the sub-1-GHz band, digital television (DTV) standard, is analyzed and chosen as the design target. The receiver achieves a noise figure (NF) of 3.6–4.6 dB in the ultrahigh-frequency (UHF) band. A wide gain tuning range of 128.8 dB is realized in this work, featuring fully integrated AGC loops. The programmable bandwidth of the low-pass filter (LPF) can be adjusted from 1 to 4 MHz, supporting 2-/6-/7-/8-MHz signal channels. The maximum in-band third-order input-referred intercept point (IIP3) is 10 dBm under the conversion gain of 0 dB. The receiver consumes 49.56 mA from a 1.8-V voltage supply and occupies an area of 3.56 mm2.

Design and implement of baseband circuits for a wireless automatic meter reading application

Design and Implementation of a Wireless Automatic Meter Reading System

Design of Wireless SEMG Acquisition Instrument

An Asynchronous GFSK Demodulator for Automatic Meter Reading

A Novel Wireless Data Acquisition System for Euro-balise

Design and implementation of baseband transmitter for UHF RFID reader

An Asynchronous Design Method and Its Application on a Low-Power RFID Baseband Processor

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

Baseband Design for Passive Semi-Uwb Wireless Sensor and Identification Systems

Design of Novel Digital GFSK Modulation and Demodulation System for Short-Range Wireless Communication Application

Design and Implementation of A Hbc Digital Baseband System for Two-Hop Extension Star Network

A Reconfigurable Analog Baseband Circuit for Wlan, Wcdma, and Bluetooth

Design and realization of UHF RFID reader digital baseband

An ultra low-power and area-efficient baseband processor for WBAN transmitter.

An Ultra Low Power Baseband Transceiver IC for Wireless Body Area Network in 0.18- \mu M CMOS Technology

A Dual-Mode Analog Baseband Utilizing Digital-Assisted Calibration for WCDMA/GSM Receivers

A 0.18 Um Cmos Reconfigurable Digital Baseband Transceiver With 2fsk For Rfid

A 1.8-V, 5-Ma Reconfigurable Analog Baseband Circuit for Low-if Multi-Mode Multi-Band Receivers

A Low-Power Robust GFSK Demodulation Technique for WBAN Applications

Design of Single-Phase Intelligent Meter Based on RFID Semi Active Technology

Design of a low-cost low-power baseband-processor for UHF RFID tag with asynchronous design technique