Abstract:It's an inevitable trend for a substation automation system (SAS) to conform to the IEC 61850 standard. The increasing application of station bus and process bus makes a strict requirement for bay level intelligent electrical devices (IEDs) with multi-network interfaces, high reliability and real-time performance. Moreover, too many IEDs in SAS will lead to multi-level switch of network in SAS and complex operation condition with poor real-time performance. The rapid development of computer technology has led to highly integrated hardware with greatly improved reliability, which makes it possible for IEDs in different bays to incorporate together so that the concept of design is based on the total substations with fewer IEDs and is in favor of the incorporation of the function between protection and control. A solution suitable for IEC 61850 based new centralized IED is proposed. Due to the strong hardware and network interfaces, a new centralized IED can replace several conventional IEDs with lower cost, dual configuration and fewer network nodes that simplifies the network connection. Some key technologies such as hardware, software structure and data exchange between different function modules are discussed. It is an approach to the implementation of SAS obeying IEC 61850.

On-line Monitoring Device in Substation Based on the Technology of CAN Bus and ARM Microprocessor

Research and Development of Comprehensive Monitoring and Management Platform for Substation

Monitor System of Energy-Feedback Electronic Load Based on CAN Bus and LabVIEW

Design of the Remote Monitoring and Fault Diagnosis System for Power Electronic Equipment

Multi-node data acquisition and analysis system for the development of AT electronic control unit.

ARM Embedded System for On-Line GIS Monitoring

The Design of MDF Remote Intelligent Supervisor System with S3C44B0X

Remote Monitoring and Alarm System based on ARM9

Remote Monitor and Control System Based on ARM9 and CAN Bus

Integrated Automation of Low Voltage Substation

Internet-based automation equipment intelligent monitor system

The Design of the Embedded Bus Controller Based on the Network Monitor System

Study on the IEC61850 Standard Applied to the On-line Monitoring of GIS

A Design of Monitoring System for Low-Voltage Distribution Station

The research of tunnel monitoring system based on CAN bus

On-Line Monitoring System of HVCB Based on FPGA and ARM

Development of contamination leakage current online monitoring system for substations

New centralized intelligent electrical device based on IEC 61850

Hierarchical distributed CAN Bus optical fibre network monitoring system

On board data monitoring system for fuel cell vehicle

A Digital Communication Network Based Remote Maintenance System for Intelligent Electronic Device of Substation