Abstract:Abstract Aiming at the problems of a single control mode, complex signal line, serious interference and poor system stability of a traditional weeding machine, a distributed control idea was proposed. Based on STM32 as the main control chip, each control unit realizes motion control, detection control, command control, and the terminal was displayed in a centralized manner. Based on ISO11783 protocol, according to the actual requirements of the weeding robot, the CAN bus communication protocol was improved and formulated to form a distributed control system. The system can completely realized all the actions of the weeding robot. 1. Motion controls: robot forwards, backwards, turning and weeding knife up or down; 2. Detection feedback: a power chassis climbing angle calculation and weeding knife speed self-adjustment, battery power, engine fuel capacity display; 3. Control command input functions. The test results had shown that the control system is stable, responsive solid, design specifications. It could meet the requirements of practical application. Meanwhile, the real-time accuracy and reliability of a CAN bus application in the agricultural production control system were verified.

The research of tunnel monitoring system based on CAN bus

Monitoring System of Shield Tunneling Machine Based on Adaptive Control Technology

Research of Multi-Axis-movement-system Based on CAN

Research of measurement and control for bearing based on distributed system

Design of Monitoring System of a Tunneling Test Bench for Large-size Full-face Shields

Condition Monitoring System of Simulator Test Rig for Shield Tunnelling Machine

Message response time distribution analysis for Controller Area Network containing errors

Design of Upper Computer System of High-End Loom Machine Controller Based on AT9261 and CAN Bus

Research on Embedded and Monitoring Test Technology of C4ISR System

Remote Monitor and Control System Based on ARM9 and CAN Bus

On-line Monitoring Device in Substation Based on the Technology of CAN Bus and ARM Microprocessor

Development of supervisory system for rubber manufacture based on CAN bus

Design of Embedded PLC Based on ARM and CAN Bus

The Design of the Embedded Bus Controller Based on the Network Monitor System

Application of CAN Bus in Data Arm Communication System

Vehicle Remote Fault Diagnosis and Monitoring System Based on CAN Bus

Design and test of a distributed control system of weeding robot based on multi-STM32 and CAN bus

Application of CAN multi-master technology in monitoring system of coal mine roof

Monitoring system for CO based on CAN bus

Design of Strength Test on Communication and Manipulation of CAN Nodes

Design and implementation of multi-channel CAN communication interface based on embedded Linux