Abstract:As motor vehicle exhaust emission causes more and more serious pollution in recent years, the natural environment and human health are facing great threats. It is of great significance to accurately measure the concentration of carbon monoxide, as one of the main pollutants of vehicle exhaust emissions. The detection system based on tunable diode laser absorption spectroscopy (TDLAS) is featured by high resolution, high sensitivity and fast response. Besides, TDLAS can eliminate the interference of the remaining gas by using tunable and narrow linewidth characteristics of semiconductor lasers, and selecting the single absorption line of specific gas, and finally realize the gas concentration inversion of high precision. Based on TDLAS, the motor vehicle exhaust component CO concentration detection system was designed and realized by using DFB laser with the center wavelength of 2330nm and selecting the absorption lines of CO gas at 2333nm. The hardware composition and software design of the system were introduced. In the experiment, motor vehicle exhaust of different vehicles was collected, and spectrum data obtained through the system components were used for CO concentration inversion. To improve the signal-to-noise ratio of the system and reduce the detection limit of the system, the balance detection technology was used in the system. Experiments show that the system has excellent stability, and can ensure accurate inversion of concentration results, and meet the real-time on-line detection of vehicle exhaust CO concentration.

Monitoring system for CO based on CAN bus

Monitor System of Energy-Feedback Electronic Load Based on CAN Bus and LabVIEW

Design of Portable Quantitative Detectors for Methane Based on MSP430

The Design and Implementation of Fault Detection System for Cab Electric Circuit of Vehicles

Measurement and control system for gas-tight deep-sea water sampler based on LabVIEW

Wireless Monitoring And Analysing System Of Dissolved Gases In The Transformer Oil

Design and Implementation of Gas Detecting Systerm Based on Microcontroller

Design of multi-component gas measurement system based on STM32

Design of Fuel Cell Vehicle Monitoring System based on CAN Network

Design of Portable Automotive Emission Analyzer Based on National Ⅳ Criteria

The design of an indoor carbon monoxide safety monitor system based on a single chip computer

Design of a Multi-Channel Gas Sensor Detection System Based on STM32 Microcontroller and LabVIEW

The design of motor vehicle exhaust carbon monoxide concentration detection system based on tunable diode laser absorption spectroscopy

General Alarming and Monitoring System Design Based on Dual-MCU

On board data monitoring system for fuel cell vehicle

Design and Implementation of Environment Monitor for Urban Rail Transit

Automatic Measurement and Control System for Vehicle ECU Based on CAN Bus

Design and Implementation of Vehicle Exhaust Gas Analyzer in NDIR Method

Real-time monitoring system of NOx and HC in vehicle exhaust based on DOAS

Design and Implementation of Vehicle Environment Monitoring System Based on Wireless Sensor Network

Online Detection System of CO in Cigarette Mainstream Smoke Based on LabVIEW