Abstract:The cold drawing of magnesium wires has constantly been an obstacle in industrial manufacture due to the lack of sufficient independent slip system at ambient temperature and the frequent intermediate annealing gives rise to regrettably low production efficiency. Aiming at the technique challenge, a feasible and effective method of multi-pass cumulative cold drawing with small deformation per pass was utilized in this study and a wire of 0.625mm in diameter was obtained out of primitive Φ2.0mm material with the accomplishment of about 2.3 in cumulative strain (90% in area reduction), the efficiency of which was dramatically improved. The microstructure, texture and mechanical properties with the variation of cumulative area reduction were investigated. It can be apparently observed that continuous dynamic recrystallization had occurred during cold drawing. The outcomes are displayed as follows: the transition emerged from low angle grain boundary to high angle grain boundary; the increased fraction of undeformed/recrystallized structure first descended then ascended; the deformed structure initially appeared yet disappeared quickly. All of above owned an almost same critical point at around 23% cumulative area reduction. One of the most remarkable consequences of the deformation was the degeneration of the average grain size steadily from 11.8 to 3.1µm. 〈10-10〉//DD fiber component was gradually transformed from the primitive {0002}//DD fiber texture and this deformation texture was continuously strengthened. The enhanced mechanical properties achieved uncommonly high strength of 214.5MPa in yield strength and 256.9MPa in ultimate tensile strength due to grain refinement arising from continuous dynamic recrystallization and intense fiber texture strengthening introduced during cold drawing.

Merging of the grains during wire drawing

Effect of drawing deformation on microstructure and mechanical properties of Fe-Cr-Co-W alloy

Relating Residual Stress and Microstructure to Mechanical and Giant Magneto-Impedance Properties in Cold-Drawn Co-based Amorphous Microwires

EFFECT OF HEAVILY DRAWING ON THE MICROSTRUCTURE AND PROPERTIES OF Cu-Cr ALLOYS

Experimental Analysis of Wire Drawing Influence on Microstructure, Texture, and Mechanical Properties of High‐Carbon Steel for Prestressing Strand

High deformation and delamination mechanisms explained through mesoscale and nanoscale phenomena in pearlitic steel wires

Evolution of zinc coatings during drawing process of steel wires

Evolution of Cementite Morphology in Pearlitic Steel Wire During Wet Wire Drawing

Fine-grained Structure and Recrystallization at Ambient Temperature for Pure Magnesium Subjected to Large Cold Plastic Deformation

Soft Magnetic Properties of Ultra-Strong and Nanocrystalline Pearlitic Wires

Effect of Cold Drawing Deformation on Themicrostructure and Evolution of Texture of Near Eutectoid Pearlitic Steel

Cementite Deformation and Dissolution in a Cold-Drawn Pearlitic Steel Wire

Effect of the techniqie of drawing with shear on the structure and the properties of low-carbon wires

Effect of Microstructure and Microtexture on the Mechanical Properties of Small-Strain Cold-Drawn Pearlite Steel Wires

Effect of Abnormal Grain Refinement on Synchronous Strengthening Behavior of Fe50Mn30Co10Cr10 High Entropy Alloys

The effect of cold drawing on the structure, tensile fracture strength and reliability of CuZrAl amorphous microwires

Microstructure and Properties of Pearlitic Steel during Cold Wire Drawing: A Residual Stress Perspective*

Influence of Large Cold Strain on the Microstructural Evolution for a Magnesium Alloy Subjected to Multi-Pass Cold Drawing

Phase transformation, texture evolution, and mechanical properties of Mg-9.5Gd-4Y-2Zn-0.3Zr alloy wires fabricated using hot drawing

Achieving Ultrafine Grain Size in Mg-Al-Zn Alloy by Cold Drawing

Grain Refinement in A Alznmgcuti Alloy by Intensive Melt Shearing: A Multi-Step Nucleation Mechanism