Abstract:Nowadays it is widely acknowledged that solar photovoltaic energy is one of the preferred options for sustainable management of the future energy needs of the world. For this, new technological processes, known as second and third generations, based on the use of thin films and nanomaterials, have recently been developed in order to reduce the cost of solar cells. Over the past few years, the yield of second-generation Cu(In, Ga)Se2 thin-film cells has exceeded 22 %. It was found that as nanostructured materials such as nanowire arrays often have a higher light absorption rate than thin films, they can therefore be used. This article aims to design and model nanostructured CIGS thin film solar cells based on indium tin oxide (ITO) nanowires. Modelling provides information on the operation of CIGS solar cells, as well as on the mechanisms of absorption and electric charge transport. The purpose of this work is to evaluate the electrical and optical characteristics (ISC, VOC, FF, η) of a ZnO/CdS/CIGS heterojunction thin film structure. Thus, an optimum efficiency of 17.57 % and a form factor of 76.56 % were achieved. Afterwards, the Mo film rear contact was replaced with ITO nanowires which were introduced into the CIGS-based solar cell. The results indicated that the solar cells under study exhibited very good photovoltaic performance, with an efficiency of 21.26 %. It is worth noting that this performance is higher than that of the corresponding CIGS thin film cells. In addition, the large active surface area of the ITO nanowire electrode and the short distance that the charge must travel helped to improve charge collection in the nanostructure. This would certainly increase the short circuit current ISC, and consequently the electrical efficiency. The simulation was based on the low-field mobility model, and on Shockley-Read-Hall (SRH) and Auger carrier transport and recombination models which may be activated in ATLAS-SILVACO (2D).

Understanding of the Relationship between the Properties of Cu(In,Ga)Se2 Solar Cells and the Structure of Ag Network Electrodes

Silver-assisted Optimization of Band Gap Gradient Structure of Cu(In,Ga)Se2 Solar Cells Via SCAPS

Cu(In,Ga)Se2 Thin Film Solar Cells with Solution Processed Silver Nanowire Composite Window Layers: Buffer/window Junctions and Their Effects

Insertion of the AGS Layer at the CIGSe/ITO Interface: A Way to Reduce the Formation of the GaOx Interfacial Phase in CIGSe Solar Cells

Hierarchical Silver Network Transparent Conducting Electrodes for Thin-Film Solar Cells

Smooth Cu electrodeposition for Cu(In, Ga)Se2 thin-film solar cells: Dendritic clusters elimination by Ag buffer layer

Reforming Material Chemistry of CIGS Solar Cells Via a Precise Ag Doping Strategy

High Efficiency CIGS Solar Cells by Bulk Defect Passivation through Ag Substituting Strategy.

Scalable CIGS Solar Cells Employing a New Device Design of Nontoxic Buffer Layer and Microgrid Electrode

The Relationships Between Electronic Properties and Microstructure of Cu(In,Ga)Se-2 Films Prepared by Sputtering from A Quaternary Target

Enhancing Surface Properties for Electrodeposited Cu(In,Ga)Se 2 Films by (NH 4 ) 2 S Solution at Room Temperature

Low-temperature Processed (ag,cu)(in,ga)se2 Thin Film Solar Cells Using Se@Ag2Se Core-Shell Hybrid Inks and Performance Optimization

Mechanism‐Based Approach of CdS/Cu(In,Ga)Se2 (CIGS) Interfaces for CIGS Solar Cells Through Deposition in Different Stages of Continuous Chemical Bath Deposition Reaction: Key to Achieving High Photovoltaic Performance

Tailored Band Structure of Cu(In,Ga)Se2 Thin-Film Heterojunction Solar Cells: Depth Profiling of Defects and the Work Function.

Electrodeposited Silver Nanowire Transparent Conducting Electrodes for Thin-Film Solar Cells

An innovative method of the vertical coupling effect improvement to the tandem Cu(In, Ga)Se2/perovskite solar cells using Ag cluster nanostructures

Reducing carrier recombination loss by suppressing Sn loss and defect formation via Ag doping in Cu2ZnSn(S,Se)4 solar cells Reducing carrier recombination loss by doping Ag in Cu2ZnSn(S,Se)4 solar cells

Properties of High Efficiency Nanostructured Copper Indium Gallium Selenide Thin Film Solar Cells

Improved sequentially processed Cu(In,Ga)(S,Se)2 by Ag alloying

Fabrication of Robust Nanoscale Contact Between a Silver Nanowire Electrode and CdS Buffer Layer in Cu(In,Ga)Se2 Thin-film Solar Cells

Improvement of the Electrical Properties of a Cu(In,Ga)Se₂ Solar Cell Based on a ZnS Buffer Layer from Radio Frequency Magnetron Sputtering