Abstract:Tip clearance refers to the radial distance from the tip of the engine rotor to the shroud, which significantly affects engine performance, as well as safety. The difference between the thermal and mechanical response of the components generates the "pinch point" clearance in the transient process, which is difficult to predict. This paper summarized a multidimensional transient model (MDTM) for clearance prediction, which was based on the temporal and spatial characteristics of components and verified by the fluid-solid-thermal coupling method (FSTM) on a single-stage turbine, and the computation cost of MDTM is only 1/1500 of FSTM. Therefore, MDTM is efficient for predicting tip clearance, especially in the early engine design stage. Meanwhile, the variant effects of different control strategies on the transient tip clearance of a baseline were explored through the approach. The control strategies consist of active clearance control methods, including controlling the cooling flow to the disk cavity and shaft speed variation time; and passive control methods, including the material type selection and geometry characteristic design. The pinch point and cruise clearance were controlled through different control strategies. Specifically, the material properties show the most significant effect on the cruise clearance (2.0% of the blade height), followed by the geometry characteristics (0.7% of the blade height). Meanwhile, the structural strength and temperature tolerance requirements should be considered first. Moreover, the mass flow rate control of the cooling flow to the disk cavity could be a potential method for tip clearance control, which affects the second pinch point and cruise clearance for 0.5% and 0.6% of the blade height, respectively. The study provides a theoretical basis for selecting a tip clearance control strategy.

Fault Tolerant Thermal Control of Steam Turbine Shell Deflections

Experimental Study on Fault Caused by Partial Arc Steam Forces and Its Economic Solution

Fault Diagnosis and Fault Tolerant Control of Wind Turbines: An Overview

Adaptive Active Fault-Tolerant Dynamic Surface Load Following Controller for a Modular High-Temperature Gas-Cooled Reactor

Non-Singular Fast Terminal Sliding Mode and Adaptive Robust Method

Research on the Axial Displacement Fault Self-recovery and Control of a High Speed Turbomachine

Thermal Adaptive Alignment Mechanism of Heavy-duty Gas Turbine Bearing Support

Optimal control of thermal and mechanical loads in activation processes of mechanical components

Active Control System of Turbine Tip Clearance

Performance Analysis of the Reheat-Stop-Valve Mechanism under Dimensional Tolerance, Misalignment and Thermal Impact

A Comprehensive Study of Tip Clearance Control Based on a Multidimensional Transient Clearance Prediction Approach

Probabilistic Analysis Method of Turbine Blisk with Multi-Failure Modes by Two-Way Fluid-Thermal-solid Coupling

Active fault tolerant control for twin wind turbine subject to asymmetric fault

Research on Active Disturbance Rejection Control Method for Turbine Blade Tip Clearance

Adaptive integral sliding mode fault‐tolerant control for diesel engine air path system via disturbance observer

Parameters control and optimization during forced cooling process after shutdown of steam turbine

Decentralized Active Disturbance Rejection Control Design for the Gas Turbine

A time-series turbofan engine successive fault diagnosis under both steady-state and dynamic conditions

Failure Mechanisms of Coating Systems Applied to Advanced Turbine Components

Neural Network-Based Adaptive Fault-Tolerant Control for Load Following of a MHTGR with Prescribed Performance and CRDM Faults

Residual Life Management System for High Temperature Steam Turbine Rotors