Abstract:The new developed metal/composite co-cured material composed of carbon fiber–reinforced plastic and Al phases has been increasingly applied for manufacturing of attitude control flywheel in aerospace industry. However, drilling of co-cured material is still a challenging task to produce holes with high quality and low cost in the assembly chain and dynamic balance debugging of attitude control flywheel. In other words, the relevant mechanisms and experimental findings involved in the drilling process of carbon fiber–reinforced plastic/Al co-cured material is not clearly defined, which impedes the progress of attitude control flywheel production. To this end, this article specially addresses the experimental studies on the drilling process of carbon fiber–reinforced plastic/Al co-cured material with standard TiAlN-coated cemented carbide twist drill. The significance of this work aims to reveal the regardful cutting responses of the hole characteristics and tool wear modes during the practical drilling process of co-cured material. A full factorial experiment including three levels of feed rate and four levels of cutting speed was performed. The hole diameter shows different values in different positions while it indicates consistent pattern regardless of the cutting variables: the largest in the Al phase, followed by the upper and lower carbon fiber–reinforced plastic phases, respectively. Grooves and matrix degradation are the major machining defects for carbon fiber–reinforced plastic layers, while a great chip debris adhered to the machined surface is the case for Al layer. Subsequent wear analysis showed that abrasion was mainly maintained at the vicinity of major/minor cutting edges and drill edge corner, followed by chip adhesion on the chisel edge region. Carbide substrate of drill flank face is exposed, and thereafter cavities are formed under the strong mechanical abrasion. These results could provide several implications for industrial manufacturers during the attitude control flywheel production.

A novel investigation on rotary tool-assisted electrical discharge-micro drilling of carbon-aramid hybrid composite

A New Strategy of Carbon Fiber Reinforced Plastic Drilling Evaluation Using Thermal Measurement

Micro drilling characterization of the carbon and carbon–aramid (hybrid) composites

Investigation of delamination and surface quality of machined holes in drilling of multiwalled carbon nanotube doped epoxy/carbon fiber reinforced polymer nanocomposite

CFRP composite drilling through electrical discharge machining using aluminum as fixture plate

Machinability Of Drilling T700/Lt-03a Carbon Fiber Reinforced Plastic (Cfrp) Composite Laminates Using Candle Stick Drill And Multi-Facet Drill

Drilling of Hybrid Titanium Composite Laminate (HTCL) with Electrical Discharge Machining

Experimental Investigation of drill tool types on delamination error in drilling of CFRP

Experimental investigation on mechanical drilling of a newly developed CFRP/Al co-cured material

Optimization of Drilling Parameters on Delamination and Burr Formation in Drilling of Neat CFRP and Hybrid CFRP Nano-Composites

An Experimental Investigation on Cutting-Induced Damage when Drilling High-Strength T800S/250F Carbon Fiber–reinforced Polymer

Effects of Specialized Drill Bits on Hoe Defects of CFRP Laminates

Drilling Machinability Evaluation on New Developed High-Strength T800s/250f Cfrp Laminates

Comparative investigations on machinability and surface integrity of CFRP plate by picosecond laser vs laser induced plasma micro-drilling

Drill-milling process and novel drill-milling tool for making a hole on carbon fiber–reinforced plastics

An Investigation of Drilling High-Strength CFRP Composites Using Specialized Drills

Hole quality in longitudinal–torsional coupled ultrasonic vibration assisted drilling of carbon fiber reinforced plastics

Hole quality and tool wear when dry drilling of a new developed metal/composite co-cured material

Rotary ultrasonic drilling of polyetherimide composite to enhance the surface roughness and MRR: Experimental investigations and statistical approach

Design and Analysis of CFRP Drilling by Electrical Discharge Machining

Comprehensive investigation of cutting mechanisms and hole quality in dry drilling woven aramid fibre–reinforced plastic with typical tools