Abstract:A stable ultrathin 2D van der Waals (vdW) heterobilayer, based on the recently synthesized boron monophosphide (BP) and the widely studied molybdenum disulfide (MoS2), has been systematically explored for the conversion of waste heat, solar energy, and nanomechanical energy into electricity. It shows a gigantic figure of merit (ZT) > 12 (4) for p (n)-type doping at 800 K, which is the highest ever reported till date. At room temperature (300 K), ZT reaches 1.1 (0.3) for p (n)-type doping, which is comparable to experimentally measured ZT = 1.1 on the PbTe-PbSnS2 nanocomposite at 300 K, while it outweighs the Cu2Se-CuInSe2 nanocomposite (ZT = 2.6 at 850 K) and the theoretically calculated ZT = 7 at 600 K on silver halides. Lattice thermal conductivity (κl ≈ 49 W m-1 K-1) calculated at room temperature is lesser than those of black phosphorene (78 W m-1 K-1) and arsenene (61 W m-1 K-1). The nearly matched lattice constants in the commensurate lattices of the constituent monolayers help to preserve the direct band gap at the K point in the type II vdW heterobilayer of MoS2/BP, where BP and MoS2 serve as donor and acceptor materials, respectively. An ultrahigh carrier mobility of ∼20 × 103 cm2 V-1 s-1 is found, which exceeds those of previously reported transition metal dichalcogenide-based vdW heterostructures. The exciton binding energy (0.5 eV) is close to those of MoS2 (0.54 eV) and C3N4 (0.33 eV) single layers. The calculated power conversion efficiency (PCE) in the monolayer MoS2/BP heterobilayer exceeds 20%. It surpasses the efficiency in MoS2/p-Si heterojunction solar cells (5.23%) and competes with the theoretically calculated ones, as listed in the manuscript. Furthermore, a high optical absorbance (∼105 cm-1) of visible light and a small conduction band offset (0.13 eV) make MoS2/BP very promising in 2D excitonic solar cells. The out-of-plane piezoelectric strain coefficient, d33 ≈ 3.16 pm/V, is found to be enhanced 4-fold (∼14.3 pm/V) upon applying 7% vertical compressive strain on the heterobilayer, which corresponds to ∼1 kbar of hydrostatic pressure. Such a high out-of-plane piezoelectric coefficient, which can tune top-gating effects in ultrathin 2D nanopiezotronics, is a relatively new finding. As BP has been synthesized recently, experimental realization of the multifunctional, versatile MoS2/BP heterostructure would be highly feasible.

Two-dimensional Mo1-xB2 with ordered metal vacancies obtained for advanced thermoelectric applications based on first-principles calculations

Microstructure and thermoelectric properties of porous Bi 2 Te 2.85 Se 0.15 bulk materials fabricated by semisolid powder processing

Large enhancement of thermoelectric performance in MoS<sub>2</sub>/<i>h</i>-BN heterostructure due to vacancy -induced band hybridization

Large enhancement of thermoelectric performance in MoS2/h-BN heterostructure due to vacancy-induced band hybridization.

High band degeneracy and weak chemical bonds leading to enhanced thermoelectric transport properties in 2H–MoTe2

MoB2:a new multifunctional transition metal diboride monolayer

Vacancy Manipulation by Ordered Mesoporous Induced Optimal Carrier Concentration and Low Lattice Thermal Conductivity in BixSb2- xTe3 Yielding Superior Thermoelectric Performance

Large Thermoelectric Power Factor of High-Mobility Transition-Metal Dichalcogenides with 1T^{″} Phase

Thermal transport and thermoelectric properties of transition metal dichalcogenides Mo X 2 from first-principles calculation

Thermal transport and thermoelectric properties of transition metal dichalcogenides Mo$X_2$ from first-principles calculation

Thermoelectric Properties of Two-Dimensional Transition Metal Dichalcogenides

Large enhancement of thermoelectric performance in MoS <sub>2</sub> / <i>h</i> -BN heterostructure due to vacancy-induced band hybridization

Enhancement of Thermoelectric Properties of Molybdenum Diselenide Through Combined Mg Intercalation and Nb Doping

Tunable Spin Transport and Spin-dependent Seebeck Effect in Boron-based Two-dimensional MBene Transition Metal Compounds

Kondo Impurities in Two Dimensional MoS2 for Achieving Ultrahigh Thermoelectric Powerfactor

Topological Electronic Transition Contributing to Improved Thermoelectric Performance in p-Type Mg3Sb2- xBix Solid Solutions

First-principles investigation of low-dimension MSe$_2$ (M = Ti, Hf, Zr) configurations as promising thermoelectric materials

Two-dimensional metal-organic frameworks with high thermoelectric efficiency through metal ion selection

Interfacing Boron Monophosphide with Molybdenum Disulfide for an Ultrahigh Performance in Thermoelectrics, Two-Dimensional Excitonic Solar Cells, and Nanopiezotronics

A First-Principles Study of 2D Bi-Based BiOClBr, BiOClI, and BiOBrI Monolayers with Ultralow Lattice Thermal Conductivities for Thermoelectric Application

First principle calculation of thermoelectric transport performance of a new dual transition metal MXene -TiZrCO2 and VYCO2