UV-Ozone Chamber Assembled for Treatment and Contact Angle Reduction on PET Surfaces

Havena Louise Pavan,Juscelino Valter Barbosas,Andreia Gerniski Macedo,Marco Aurélio Toledo da Silva,Carlos Eduardo Cava

DOI: https://doi.org/10.1109/mim.2024.10473017

2024-03-22

IEEE Instrumentation and Measurement Magazine

Abstract:A low-cost UV-Ozone chamber showed promising results for improving adhesion on PET substrates. Exposure times and temperatures were applied, revealing that with 2 hours of exposure, the transmittance remained intact, and the contact angle was reduced by 30°. This process makes the PET substrate change from hydrophobic to hydrophilic, favoring the deposition of water-based materials. It was also proven, by FTIR analysis, that UV-Ozone exposure promotes permanent changes at ester and terephthalate groups on PET substrates. The AFM analysis demonstrated that the films' roughness significantly affects the substrates' hydrophilicity. The film's hydrophilic characteristics remain stable for more than 24 hours; however, a reduction of 15° is observed in the first hour after UV lighting is switched off.

engineering, electrical & electronic,instruments & instrumentation