Abstract:This paper considers the quantitative implications of out-of-focus regions on the lateral and depth resolution of Raman microscopy, with special regard for the surface specificity of the technique. It builds on work that has recently appeared in the literature which shows that with transparent samples, signals can originate throughout a large extended illumination volume, even though most of this region is out of focus with regard to the confocal aperture. This gives rise to weak but readily detectable spectral contributions from regions that are tens of micrometers from the point of tightest focus, an effect that is easily demonstrated if the laser is focused far above the sample surface. When we integrate the signals arising throughout this extended volume, the resulting total signal can be significant with respect to the Raman signals originating from the point of focus; this has obvious implications for surface specificity and depth resolution. Furthermore, as one moves the focal point through and above a sample surface, signals from thick transparent samples decay relatively slowly compared with thin or opaque ones, where the extended focal volume is irrelevant. This means that on moving above the surface of a thinly coated thick substrate during a confocal axial scan, the substrate-to-coating signal ratio increases dramatically, contrary to intuition. Consequently, confusing spectral artifacts arise if one focuses above the sample surface, either inadvertently when mapping an uneven sample, or deliberately in an attempt to improve surface specificity. In this work we show how a simple analytical model can predict the surface/substrate signal ratio as a function of distance above the surface. The model is validated using experimental data from monofilms and coated films. Furthermore, we show how this effect is not limited to the confocal axial profiling geometry. Similar effects are obtained when one scans laterally beyond the edge of mechanically prepared cross-sections due to an extended, out-of-focus laser field that can sample lateral regions far to the side of the optimum focus. This effect can lead to very confusing results, such as spectra from the substrate increasing in absolute intensity as one moves beyond the edge of the coating into the air. These observations, which as far as we are aware have not previously been reported, are rationalized using a simple ray-tracing description, which shows the potential for coupling light into the cross-section, which acts as a waveguide. These effects have a completely different origin than the well-known anomalies that are introduced by refraction and spherical aberration; even with a perfect, aberration-free system, the extended focal volume may cause significant degradation in depth resolution. Although the effects have been demonstrated with simple film systems, they have the potential to impact the results from Raman mapping and imaging of any samples that contain significant refractive index discontinuities, which can potentially cause refraction and waveguiding, or that have compositional depth gradients and an uneven sample surface.

Effects of refractive index mismatch between sample and immersion medium in line-field confocal optical coherence tomography

High-Resolution Computed Tomography of Refractive Index Distribution by Transillumination Low-Coherence Interferometry

Defocus test and defocus correction in full-field optical coherence tomography

Measuring the refractive index and thickness of multilayer samples by Fourier domain optical coherence tomography

Harnessing Forward Multiple Scattering for Optical Imaging Deep Inside an Opaque Medium

Determination of scattering coefficient and scattering anisotropy factor of tissue-mimicking phantoms using line-field confocal optical coherence tomography (LC-OCT)

Quantitative 3D refractive index tomography of opaque samples in epi-mode

High-fidelity optical diffraction tomography of live organisms using iodixanol refractive index matching

Snapshot coherence-gated direct wavefront sensing for multi-photon microscopy

The influence of out-of-focus sample regions on the surface specificity of confocal Raman microscopy

Optical diffraction tomography microscopy with transport of intensity equation using a light-emitting diode array

Comparative analysis of full-field OCT and optical transmission tomography

Interface Self-Referenced Dynamic Full-Field Optical Coherence Tomography

Anisoplanatic adaptive optics in parallelized laser scanningmicroscopy

Confocal Raman Microscopy with Adaptive Optics

Co-localized line-field confocal optical coherence tomography (LC-OCT) and confocal Raman microspectroscopy for ex vivo analysis of skin tissues

3D correlative single-cell imaging utilizing fluorescence and refractive index tomography

Imperfect refractive index matching in scanning laser optical tomography and a method for digital correction

Correcting for objective sample refractive index mismatch in extended field of view selective plane illumination microscopy