Abstract:In this study, a series of hypervelocity impact tests were carried out based on a two-stage light gas gun, and the sequence spectrum and radiation evolution data of the impact products under different impact conditions were obtained. The diameter of the projectile is 3–5 mm, the impact velocity is 3.13–6.58 km/s, and the chamber pressure is 0.56–990 Pa. The spectrum of ejected debris cloud in the 250–310 nm band were obtained using a transient spectral measurement system and a multi-channel radiometer measurement system. The test results reveal that the flash radiation intensity increases as a power function with the kinetic energy of the impact. Furthermore, the peak value of the line spectrum decreases as the chamber vacuum degree increases, while the radiation width gradually expands. The line spectrum in the spectral characterization curve corresponds to the ejected debris clouds splitting phase, which does not produce significant line spectrum during material fragmentation and is dominated by the continuum spectrum produced by blackbody radiation. There will appear one or three characteristic peaks in the flash radiation time curve, the first and second peaks correspond to the penetration phase and the third peak corresponds to the expansion phase of the ejected debris clouds on the time scale, the first and second peaks are more sensitive to the chamber vacuum degree, and when the pressure is higher than 99 Pa, the first and second characteristic peaks will disappear. The radiant heat attenuation of the flash under different impact conditions is significantly different, the attenuation exponent has a power function relationship with the impact velocity and the chamber vacuum degree, while the attenuation exponent has a linear relationship with the diameter of the projectile, the specific expression of the attenuation exponent is obtained by fitting. The findings from this research can serve as a valuable reference for remote diagnostic technologies based on flash radiation characteristics.

Hypersonic impact flash characteristics of a long-rod projectile collision with a thin plate target

Damage Characteristics of Aluminum Nanorod under Hypervelocity Impact

Energy distribution characteristic of impact flash of metallic target impacted by hypersonic projectile

Experimental investigation of spectral evolution in flash radiation by hypervelocity impact on aluminum plates

Experimental of Plasma from Hypervelocity Impact

Plasma and Light Flash Radiant Features Generated by Al/PTFE Projectile High-Velocity Impact Thin Aluminum Target

Light Emission and Dynamic Failure Mechanism of Hypervelocity Impact on Zr-Ti-Ni-Cu-Be Bulk Metallic Glass

Experimental investigation for deformation and fragmentation of spheres penetrating sheets at hypervelocity

Analysis of Debris Clouds Produced by Impact of Aluminum Spheres with Aluminum Sheets

Hypervelocity Impact Induced Light Flash Experiments on Single and Dual Layer Kapton Targets to Develop a Time of Flight Space Dust and Debris Detector

Atomistic Simulations on Metal Rod Penetrating Thin Target at Nanoscale Caused by High-Speed Collision

Characteristics of Acoustics Emission Signals Produced by Hypervelocity Impact

Insights into microstructural evolution and deformation behaviors of a gradient textured AZ31B Mg alloy plate under hypervelocity impact

Damage of Ti-6al-4v Alloy Induced by Hypervelocity Impact

Investigation into Damage of Stainless Steel Mesh/Al Plate Multi-Shock Shield under Hypervelocity Al-Spheres Impact

Effects of Friction and Plastic Deformation in Shock-Comminuted Damaged Rocks on Impact Heating

Dynamic Response and Numerical Simulation of Al-Sc and Al-Ti Alloys under High-Speed Impact

Residual microstructure and damage geometry associated with high speed impact crater in Al 2O 3 and TiB 2 particles reinforced 2024 Al composite

The damage characteristics and formation mechanism of ultrahigh strength 7055 aluminum alloy under hypervelocity impact

Deformed Microstructure of AZ91 Magnesium Alloy Impacted by Projectiles with Velocities of 2-3 Km/s

Synergistic Effect of Energy Absorption and Adiabatic Temperature on the Microstructural Evolution and Mechanical Properties During High-Speed Impacts