Abstract:In this research, the mechanical behaviors of extruded AZ31B Mg plate along normal direction (ND) were investigated over a wide range of strain rates. High strain rate tests were carried out using a split Hopkinson pressure bar at room temperature. The corresponding deformation mechanisms, texture evolution and microstructure changes were analyzed by utilizing optical microscope (OM), X-ray diffraction (XRD), electron backscatter diffraction (EBSD) and transmission electron microscopy (TEM). It is found that the mechanical responses exhibit both sigmoidal hardening and power-law hardening behaviors under compression at high strain rate ranges of 1068-5647 s(-1). The prismatic type textures of the skin layer and center layer of the AZ31B plate determine its mechanical behaviors. The sigmoidal hardening behaviors are resulted from the formation and development of {10-12} extension twinning at the initial stage of deformation. Whereas the power-law hardening behaviors are resulted from non-basal < c+a > dislocation slip dominated the deformation at the initial deformation stage. Experimental results indicate the critical resolved shear stress (CRSS) for extension twinning and non-basal < c+a > dislocation slip are insensitive to strain rate, but the latter CRSS is significantly higher than the former CRSS. The flow stress is insensitive to strain rate if plastic deformation is dominated by extension twinning, while it increases with the increase of strain rate if plastic deformation is dominated by nonbasal < c+a > dislocation slip. Dynamic recrystallization (DRX) took place if the AZ31B plate was compressed at strain ranges of 4737-5647 s(-1), resulting in a decrease in flow stress and a significant increase in ductility. (C) 2016 Elsevier B.V. All rights reserved.

Insights into microstructural evolution and deformation behaviors of a gradient textured AZ31B Mg alloy plate under hypervelocity impact

Damage Characteristics of Aluminum Nanorod under Hypervelocity Impact

Mechanical properties and fracture behavior of Mg–3Al–1Zn alloy under high strain rate loading

The damage characteristics and formation mechanism of ultrahigh strength 7055 aluminum alloy under hypervelocity impact

Dynamic mechanical response and microstructural evolution of extruded Mg AZ31B plate over a wide range of strain rates

High Strain-Rate Behavior and Deformation Mechanism of a Multi-Layer Composite Textured AZ31B Mg Alloy Plate

Dynamic plasticity of AZ31 magnesium alloy: Experimental investigation and constitutive modeling

Local deformation of Mg–7Gd–5Y–1.2Nd–0.5Zr magnesium alloy under high speed impact along extrusion direction

Dynamic Hardness Evolution in Metals from Impact Induced Gradient Dislocation Density

Ballistic response and failure mechanisms of gradient structured Mg alloy

Dynamic Response and Numerical Simulation of Al-Sc and Al-Ti Alloys under High-Speed Impact

Research on impact resistance of ZK61m magnesium alloy thin plate under different working conditions

Unveiling the mechanical response and accommodation mechanism of pre-rolled AZ31 magnesium alloy under high-speed impact loading

Role of Crystal Orientation in the Dynamic Strength of Magnesium Alloy AZ31B

Synergistic Effect of Energy Absorption and Adiabatic Temperature on the Microstructural Evolution and Mechanical Properties During High-Speed Impacts

Grain size and orientation affected deformation inhomogeneity and local damage of hot-deformed Al-Zn-Mg alloy

Ballistic impact response of a heat-treated dual-phase Ti–5.2Mo–4.8Al–2.5Zr–1.7Cr alloy with hierarchical microstructure

Deformation behavior and microstructure evolution of AZ31 Mg alloy during gradient thermal compression

Dynamic mechanical response and deformation-induced co-axial nanocrystalline grains facilitating crack formation in magnesium-yttrium alloy

Microstructural evolution and dynamic recrystallization model of extruded homogenized AZ31 magnesium alloy during hot deformation

Influence of impact velocity on impact-initiated reaction behavior of Zr-Ti-Nb alloy