Abstract:The study presented in the article focuses on modelling of thin-walled cylindrical shell structures with initial geometrical imperfections under external radial pressure. The critical pressure of the perfect shell obtained using linear analysis significantly exceeded that calculated by the Papkovich formula. This discrepancy can be attributed to the shell displacement constraints and the fact that linear analysis provides non-conservative estimates. Initially, the geometric imperfections were assumed to follow an eigenmode-affine pattern with varying amplitudes. Critical pressure values iteratively determined using the modified Ricks method were found to be lower than the critical pressure of the first buckling mode. Importantly, all these values remained notably higher than the normative value. Subsequently, the initial imperfections were modelled as combinations of sinusoidal deviations with different amplitudes and varying numbers of waves along the perimeter. Short-wavelength eigenmode-affine imperfections were superimposed on longer-wavelength deviations. The research indicated that while the long-wavelength imperfections had a marginal impact on the critical pressure values, they notably altered the post-buckling behaviour of the shell, as depicted in load-deflection figures in the form of loops. These processes occurred at pressure levels considerably higher than the normative value. The simulation results are in good agreement with established theories regarding the pre- and post-buckling behaviour of thin-walled shells. Nonlinear analysis revealed that the actual critical pressure values exceeded the normative value by 30-45%, and the post-buckling pressure values exhibited a gradual decrease without posing a threat to abrupt changes in the geometry of the shells. This outcome provides a basis for a more accurate estimation of the load-carrying capacity of the shell structures.

Buckling failure analysis of PMMA spherical pressure hull

Form of Circumferential Weld-Induced Imperfections for Tapered-Wall Cylindrical Shell Structures

Advances in Buckling Analysis of Axial Compression Loaded Thin-walled Cylindrical Shells Based on Initial Imperfection Sensitivity

Buckling Strength of Tapered Cylindrical Shells under Partial Axial Compression: Effect of Circumferential Weld-Induced Imperfections

Buckling Behavior Analysis of Thin-Walled Cylindrical Shell Structure under Localized Axial Compression Load Based on Initial Imperfection Sensitivity

Buckling of cylindrical shells with general axisymmetric thickness imperfections under external pressure

Analytical Study on the Buckling of Cylindrical Shells with Arbitrary Thickness Imperfections under Axial Compression

Research on Buckling Load Numerical Method of Cylindrical Shells with Initial Imperfection

Buckling Pressure of Imperfect Spherical Shell Damaged by Concentrated Impact Load

Buckling of composite cylindrical shells with ovality and thickness variation subjected to hydrostatic pressure

Experimental and Numerical Investigation of Material Failure Criterion with High-Strength Hull Steel under Biaxial Stress

Postbuckling Behaviour of Anisotropic Shear Deformable Laminated Cylindrical Shells with General Imperfection Distribution Subjected to Torsion

Limit pressure and design criterion of cylindrical pressure vessels with nozzles

Numerical Study on Buckling Behaviors of Thin-Walled Longitudinal Corrugated Cylindrical Shells under Axial Compression Loads

Isogeometric Method for Buckling Prediction and Post-Buckling Analysis of Variable Stiffness Composite Underwater Pressure Shell

A New Design Method For Axially Loaded Thin-Walled Cylindrical Shells Based On Elasto-Plastic Buckling Analysis

Numerical Simulation on Buckling of Combined Multilayered Unequal-Thickness Cylindrical Shell

Influence of Initial Imperfections on Ultimate Strength of Spherical Shells

The most severe imperfection governs the buckling strength of pressurized multi-defect hemispherical shells

Computer modelling of thin-walled shell structures with geometric imperfections

Dieless Bulging and Nonlinear Buckling of Longan-Shaped Pressure Hull