Simulation and Analysis of a Split Drill Bit for Pneumatic DTH Hammer Percussive Rotary Drilling

Yuanling Shi,Conghui Li
DOI: https://doi.org/10.1155/2024/4614348
IF: 2.006
2024-01-04
Geofluids
Abstract:Reverse circulation impact drilling has the advantages of high drilling efficiency and less dust, which can effectively form holes in hard rock and gravel layer. As integral reverse circulation drill bits used in the conventional down-the-hole (DTH) hammers are only suitable for specific formations, the whole set of DTH hammer needs to be replaced when drilling different formations. In this paper, several types of split drill bits for different drilling technologies are designed. The flow field characteristics of one of the split drill bits is analyzed based on the computational fluid dynamics (CFD) method, with four technic parameters considered, which are input flow rate, number of inlet holes, angle of injection exhaust holes, and diameter of injection exhaust holes, respectively. Three parameters are selected as indicators to evaluate the rationality and performance of the split drill bit, which are injection exhaust hole outlet mass flow rate, ratio of the mass flow rate out of injection exhaust holes to the whole inlet mass flow rate, and maximum pressure at the upper end of the split drill bit. According to the CFD analysis results, the above four technic parameters influence the flow rate and pressure in different rules. Considering the injection capacity, pressure loss, and bit strength, inlet holes of 10, injection exhaust holes with an angle of 50°, and injection exhaust holes with a diameter of 12 mm are recommended to obtain ideal reverse circulation. Different types of split drill bits were manufactured, and drilling experiments were carried out in unconsolidated formations. The maximum drilling rate can reach 1.5 m/min in the drilling experiments. The split drill bit proposed in this paper exhibits excellent adaptability for reverse circulation drilling in loose formations.
geochemistry & geophysics,geology
What problem does this paper attempt to address?
The problem that this paper attempts to solve is the limitations of the traditional integral reverse - circulation bit when conducting efficient drilling under different stratum conditions. Specifically, the paper addresses the following issues: 1. **Poor adaptability**: Traditional integral bits are only suitable for specific stratum conditions. When drilling in different strata is required, the entire DTH hammer must be replaced, which increases equipment investment and maintenance costs. 2. **Complex structure**: The internal gas distribution channel design of the integral bit is complex and difficult to process, resulting in poor cooling effect and insufficient cuttings discharge capacity, thus accelerating bit wear and reducing drilling speed. 3. **Easily damaged**: Traditional bits are prone to failure under high - frequency impacts, such as tooth breakage or loss, which causes the entire bit to be scrapped and increases maintenance costs. To solve these problems, the paper designed multiple split - type bits and analyzed the flow field characteristics of one of the split - type bits by the computational fluid dynamics (CFD) method. The influence of four technical parameters on the flow field characteristics was mainly studied, and these parameters include: - **Input flow rate**: The gas flow rate input into the bit. - **Number of air inlet holes**: The number of air inlet holes on the bit. - **Angle of jet exhaust holes**: The angle of the jet exhaust holes. - **Diameter of jet exhaust holes**: The diameter of the jet exhaust holes. Through these analyses, the paper aims to optimize the design of the split - type bit to improve its reverse - circulation drilling efficiency and adaptability in loose strata. According to the CFD analysis results, the following parameter combinations are recommended to obtain the ideal reverse - circulation effect: - Number of air inlet holes: 10 - Angle of jet exhaust holes: 50° - Diameter of jet exhaust holes: 12 mm In addition, the paper also carried out field tests to verify the performance of the split - type bit in the gravel layer. The experimental results show that the maximum drilling speed can reach 1.5 meters per minute, indicating that the proposed split - type bit has excellent adaptability in loose strata.