Abstract:Thin-walled structures are now widely used in aerospace structural components, turbines and many other applications, while the control of machining distortion has become one of the most difficult problems influencing their machining quality. Machining distortion is the result of many factors, among which the machining induced residual stress is an important issue. In this paper, a finite element analysis (FEA) approach of predicting machining induced residual stresses and the consequent distortion is presented, which includes the simulation of machining process, processing of the extracted residual stress data, loading of the fitted stress data and distortion analysis. Professional metal cutting simulation and optimization software, TWS AdvantEdge, was used for 3D machining process simulation. The constitutive model of work piece material was obtained from pressure bar tests and orthogonal cutting tests, and has been proved of good accuracy. General FEM software ABAQUS was used to create and mesh the thin-plate work piece. The meshing data outputted from ABAQUS and stress data calculated by AdvantEdge were processed with MATLAB, obtaining the stress distribution of each element, and then the stress distribution was input back into ABAQUS to calculate the distortion. Experiments were carried out, measuring the residual stress and distortion, to verify the FEM simulation. Under the designed simulation and experiment conditions, the machining induced residual stresses in feeding and peripheral directions are both tensile at the machined surface and fall off to a maximum compressive state with the increase in depth, after which the compressive stresses decrease and approach a steady value next to zero in near work piece substrate. Both experimental and FEA simulation results show that the release of the residual stresses make the thin plate to become convex. Yet there are still differences in conditions between simulation and experiment, and further will be carried out- to improve the accuracy.

Analytical model for measurement of through-thickness axisymmetric radial residual stress

Study on Measurement Method of Interior Stress Distributions in Engineering Rolled-Plates

Analysis and Simulation of Machining Deformation Resulting from Residual Stress

Improvement of Finite Element Analysis of Calibration Coefficients for Hole-Drilling Method by General Axisymmetric Elements

On the Sensing and Calibration of Residual Stresses Measurements in the Incremental Hole-Drilling Method

Analytical modeling of milling residual stress under different tool wear conditions

A modeling of residual stress in stretched aluminum alloy plate

Finite element analysis of residual stresses and thin plate distortion after face milling

A Porosity Closure Model Considering Stress Triaxiality Ratio and Lode Stress Parameter

A 3D Analytical Model for Residual Stress in Flank Milling Process

Prediction of stress distribution in press-fit process of interference fit with a new theoretical model

A novel model to obtain equi-biaxial residual stress of metallic materials via instrumented spherical indentation

Analysis of Residual Stresses Induced by Riveting Process and Fatigue Life Prediction

A Mathematical Model for Predicting Residual Stresses in Pre-Stretched Aluminum Alloy Plate

An Analytical Model of Residual Stress in Orthogonal Cutting Based on the Radial Return Method

3D numerical modelling of residual stresses induced by reaming

The Stress Concentration in Finite-Size Plates Containing Elliptical Holes with a Direct Solution of Complex Series

Simplified Model for Bearing Stiffness Based on Plate Theory

Measurement of Non-Uniform Residual Stresses by Combined Moiré Interferometry and Hole-Drilling Method: Theory, Experimental Method and Applications

A Finite Element Analysis of Residual Stress of Focal Plate on ANSYS/LS-DYNA

Numerical Analysis of Residual Stress due to Surface Induction Hardening