Abstract:Low-cycle fatigue (LCF) behavior of nickel-based precipitation-strengthened superalloy GH4145/SQ was investigated systematically under fully reversed total strain amplitude control conditions at 538°C in laboratory air. It was shown that the alloy exhibited a pronounced initial fatigue hardening followed by continuous fatigue softening to failure at high strain amplitudes, while at low strain amplitudes the initial hardening was followed by a well-defined saturation stage. Microstructure observations using optical and transmission-electron microscopy revealed that slip band density increased with increasing total strain amplitudes and the size of the γ′precipitates tended to reduction due to repeated shearing by the dislocations with continuous cyclic straining. The above changes in microstructures during cycling were essentially responsible for the fatigue hardening–softening behavior of the alloy. Both optical and SEM micrographs indicated that at low strain amplitudes crack propagation was basically transgranular, while at high strain amplitudes crack propagation was essentially intergranular. Bilinear behavior with a change of slope at a plastic strain amplitude of about 0.2pct was observed in cyclic stress–strain (CSS), Coffin–Manson (C–M) and plastic strain energy–life plots. A change in the number of operating slip systems and the fracture modes with the strain amplitude employed was used to explain this two-slope characteristic. In both the companion specimens test (CST) and the incremental step test (IST) methods the alloy exhibited non-masing type behavior. It was suggested that, for the first approximation, the half-life plastic strain energy could be calculated directly according to the equation without reckoning in the non-masing behavior.

Ultra-long life fatigue behavior of a high-entropy alloy

Ultrahigh Cryogenic Strength and Exceptional Ductility in Ultrafine-Grained CoCrFeMnNi High-Entropy Alloy with Fully Recrystallized Structure

Low cycle fatigue behavior of nickel-based superalloy GH4145/SQ at elevated temperature

Fatigue Behavior of A Wrought Al0.5cocrcufeni Two-Phase High-Entropy Alloy

Enhancing the fatigue property of high entropy alloy by regulating characteristics of grains and precipitates

Fatigue Behaviour and Crack Initiation in CoCrFeNiMn High-Entropy Alloy Processed by Powder Metallurgy

Fatigue crack growth behavior in CoCrFeMnNi high entropy alloy with harmonic structure topology

Fatigue behavior of high-entropy alloys: A review

Fatigue Behavior of High-Entropy Alloys

Microstructure sensitivity of the low cycle fatigue crack initiation mechanisms for the Al 0.3 CoCrFeNi high entropy alloy: in-situ SEM study and crystal plasticity simulation

High-cycle fatigue and tensile deformation behaviors of coarse-grained equiatomic CoCrFeMnNi high entropy alloy and unexpected hardening behavior during cyclic loading

An Overview on Fatigue of High-Entropy Alloys

Temperature-dependent fatigue response of a Fe44Mn36Co10Cr10 high entropy alloy: A coupled in-situ electron microscopy study and crystal plasticity simulation

Microstructure relevant fatigue short crack propagation behavior of Al 0.3 CoCrFeNi high entropy alloy: in-situ SEM study

Enhancing fatigue life by ductile-transformable multicomponent B2 precipitates in a high-entropy alloy

Low cycle fatigue performances of Al 0.3 CoCrFeNi high entropy alloys: In situ neutron diffraction studies on the precipitation effects

Cyclic plasticity of an interstitial high-entropy alloy: experiments, crystal plasticity modeling, and simulations

Enhancement of fatigue resistance by overload-induced deformation twinning in a CoCrFeMnNi high-entropy alloy

Crack initiation mechanisms and life prediction of GH4169 superalloy in the high cycle and very high cycle fatigue regime

Abnormal hardening and amorphization in an FCC high entropy alloy under extreme uniaxial tension

Microstructure and Mechanical Properties of Face‐Centered‐Cubic‐Based Cr‐Free Equiatomic High‐Entropy Alloys