Abstract:Thermochemical recuperation heat recovery is an advanced waste heat utilization technology that can effectively recover exhaust waste heat from oxy-fuel Stirling engines. The novel combustor of a Stirling engine with thermochemical recuperation heat recovery system is expected to utilize both reformed gas and diesel fuels as sources of combustion. In this research, the effects of various factors, including the H 2 O addition, fuel distribution ratio (FDR), excess oxygen coefficient, and cyclone structure on the temperature distribution in the combustor, combustion emissions, and external combustion system efficiency of the Stirling engine were experimentally investigated. With the increase of steam-to-carbon ratio (S/C), the temperature difference between the upper and lower heating tubes reduces and the circumferential temperature fluctuation decreases, and the combustion of diesel and reformed gas remains close to complete combustion. At S/C=2, the external combustion efficiency is 80.6%, indicating a 1.6% decrease compared to conventional combustion. With the increase of FDR, the temperature uniformity of the heater tube is improved, and the CO and HC emissions decrease. However, the impact of the FDR on the maximum temperature difference and temperature fluctuation across the heater is insignificant. When the FDR rises from 21% to 38%, the external combustion efficiency increases from 87.4% to 92.3%. The excess oxygen coefficient plays a secondary role in influencing temperature uniformity and temperature difference, and the reformed gas and diesel fuel can be burned efficiently at a low excess oxygen coefficient of 1.04. With an increase in the cyclone angle, the heater tube temperature increases, while the maximum temperature difference at the lower part decreases, and the temperature fluctuation increases. Simultaneously, the CO and HC emissions increase, and the external combustion efficiency experiences a decrease. A cyclone angle of 30° is found to be an appropriate value for achieving optimal mixing between reformed gas and diesel fuel. The research findings present valuable new insights that can be utilized to enhance the performance optimization of Stirling engines.

Flow and heat transfer characteristics of torsional tube cluster heater in a Stirling engine

Experimental Study on Heat Transfer of Oscillating Flow of A Tubular Stirling Engine Heater

Working Mechanism and Characteristics of Gas Parcels in the Stirling Cycle

Effects of different working gases on the heat transfer enhancement performance of a heating tube with spiral insert under oscillatory flow

Numerical simulation on heat transfer enhancement of free piston Stirling engine heater with composite cross section mini channels

Heat transfer characteristics of enhanced cooling tube with a helical wire under oscillatory flow in Stirling engine

Evaluation of heat transfer enhancement effect at the hot/cold end of a Stirling engine using performance improvement factor

Heat transfer characteristics of the oscillating flows of different working gases in U-shaped tubes of a Stirling engine

A Third-Order Numerical Model and Transient Characterization of a Β-Type Stirling Engine

Numerical Investigation On Nonlinear Effect And Vortex Formation Of Oscillatory Flow Throughout A Short Tube In A Thermoacoustic Stirling Engine

Characteristics of Steady and Oscillating Flows Through Regenerator

Turbulent flow and heat transfer in a new type of internally torsion-ribbed helical tube

Design Optimization with Computational Fluid Dynamic Analysis of Β-Type Stirling Engine

Characteristics and potential of a novel inclined-flow stirling regenerator constructed by sinusoidal corrugated channels

Influence of Compression-Expansion Effect on Oscillating-Flow Heat Transfer in A Finned Heat Exchanger

Investigation on streaming in a Stirling thermoacoustic engine

Experimental Investigation on Heat Transfer and Combustion of a Stirling Engine Combustor Fueled by Reformed Gas and Diesel Fuel

Study of oscillating flows through a novel constructal bifurcation Stirling regenerator

MEASUREMENTS OF UNSTEADY CONVECTIVE HEAT TRANSFER RATES WITHIN A STIRLING REGENERATOR MATRIX SUBJECTED TO OSCILLATORY FLOW

Thermal Performance of a Novel Non-Tubular Absorber with Extended Internal Surfaces for Concentrated Solar Power Receivers

Convective meta-thermal concentration for ultrahigh efficient Stirling engine with waste heat and cold utilization