Abstract:Injecting CO2 pre-pad into tight reservoirs before hydraulic fracturing is a promising way to improve the productivity of single well. In this method, CO2 should be injected into the formation at a high rate. Also the miscibility of CO2 and oil with the changes of intricate geomechanics during this process are complex. Meanwhile, the geological and operating parameters have a dramatic influence to oil production and is lack of systematic research. In this study, a fluid model of crude oil was established to evaluate the impact of CO2 on oil volume and viscosity. Then, a compositional numerical model coupled miscibility and geomechanics were set up to analyze enhanced oil recovery (EOR) potential under different miscible degree with in-situ stress field. Ultimately, in accordance with multiple nonlinear regression production forecast models, Sobol, FAST (Fourier Amplitude Sensitivity Test), and DGSM (derivation-based Global Sensitivity Measure) methods were utilized to study the main factors affecting cumulative production. The results shown that CO2 almost has the same effect on the volume of these tight oil and has the most significant effect on the viscosity of crude oil we studied by comparing. The production of miscible flooding is 38.2% and 16.4% higher than that of immiscible and near-miscible flooding, respectively. The formation were compacted during production especially in the early stage, hence the production of the model with geomechanics was 23.3% less than the model of non-geomechanics. The first-order sensitivity indexes of bottom-hole flow pressure, reservoir thickness and fracture conductivity are about 0.808, 0.176 and 0.004 respectively obtained by Sobol method, consistent with two other methods. This result shows that bottom-hole flow pressure, reservoir thickness and fracture conductivity are the most important factors affecting production, and bottom-hole flow pressure has the most significant impact on production. This work investigates how miscibility and geomechanics effect on production as well as clarified the factors affecting production for CO2 pre-pad injection, providing vital insights into operating in tight reservoirs for oil field.

Uncertainty quantification for CO2 sequestration and enhanced oil recovery

Pore-scale characterization of carbon dioxide storage at immiscible and near-miscible conditions in altered-wettability reservoir rocks

A novel technique for quantifying the fate of CO 2 injected in oil reservoir for geological utilization and storage

An Uncertainty Quantification Framework for Studying the Effect of Spatial Heterogeneity in Reservoir Permeability on CO2 Sequestration

Uncertainty Analysis of the Storage Efficiency Factor for CO2 Saline Resource Estimation

Reservoir heterogeneity controls of CO 2 -EOR and storage potentials in residual oil zones: Insights from numerical simulations

Pore-scale flow simulation of supercritical CO2 and oil flow for simultaneous CO2 geo-sequestration and enhanced oil recovery

Uncertainty Quantification for Evaluating Impacts of Caprock and Reservoir Properties on Pressure Buildup and Ground Surface Displacement During Geological CO2sequestration

Uncertainty Quantification in CO2 Trapping Mechanisms: A Case Study of PUNQ-S3 Reservoir Model Using Representative Geological Realizations and Unsupervised Machine Learning

Assessment of chemo-mechanical impacts of CO2 sequestration on the caprock formation in Farnsworth oil field, Texas

Chemical‐Mechanical Impacts of CO2 Intrusion into Heterogeneous Caprock

Uncertainty Quantification of Fluid Leakage and Fault Instability in Geologic CO2 Storage

A Molecular Dynamics Study on Low-Pressure Carbon Dioxide in the Water/Oil Interface for Enhanced Oil Recovery

A numerical simulation study of CO2 injection for enhancing hydrocarbon recovery and sequestration in liquid-rich shales

Investigation of CO 2 -EOR and storage mechanism in Injection-Production coupling technology considering reservoir heterogeneity

Numerical study on the geomechanical responses in the Jilin Oilfield CO 2 -EOR and CGS projects in China

CO2-prepad injection EOR simulation and sensitivity analysis considering miscibility and geomechanics in tight oil reservoirs

Investigation of gravity influence on EOR and CO2 geological storage based on pore-scale simulation

Multi-Scale Seismic Measurements for Site Characterization and CO2 Monitoring in an Enhanced Oil Recovery/Carbon Capture, Utilization, and Sequestration Project, Farnsworth Field, Texas

Upscaling CO2 Foam for EOR as CCUS from On- To Offshore