Abstract:The beam current transformer (CT) is an important part of the beam diagnostics system as a kind of nondestructive intensity measurement. The beam CT has the strong dependence of the sensitivity and time constant on the time structure of the beam. To measure the macropulse beam intensity with 5-10μs length and 238 MHz micro pulse repetition rate in the IR-FEL facility [1]. It is necessary to find a suitable material as the CT core which can meet the measure requirement of the beam current. In this paper, we figured out the key factor of the suitable material to be the CT core and three different magnetic materials were tested to find out that the laminated Febased nanocrystalline alloy core owned the best performance. Then, we designed the mechanical structure and improved the test device. The finished products have passed the acceptance test. INTRODUCTION The Infrared Free Electron Laser (IR-FEL) facility is currently under construction, which provides electron energy from 15 to 60 MeV, beam bunch with a macropulse length of 5-10 μs and a general micro-pulse repetition rate of 238 MHz. The beam current will be a first check concerns in the future daily operation. So it is important to develop a reliable beam current transformer which can meet the requirement to measure intensity and time structure of the bunch. The CT is non-intercepting, whose basic principle is the detection of the magnetic field carried by the beam. In the beam detection positon of the vacuum chamber, there will be a ceramic slit, and an outer ring with high magnetic permeability. Then an N-turn coil on the magnetic ring will pick up the electricity signal. A shielding box will stop the wall current to make sure that only the beam current pass through the beam current transformer. Figure 1 shows the schematic of the beam current transformer. The inductance of the magnetic ring is determined by

High Inductance Cryogenic Current Comparators for Beamlines

Dark Current Measurements on a Superconducting Cavity using a Cryogenic Current Comparator

Cryogenic loss monitors with FPGA TDC signal processing

Performance investigation of conduction-cooled cryogenic permanent magnet undulator at high beam currents

High Power Test Of A 3.9 GHz 5-cell Deflecting-mode Cavity In A Cryogenic Operation

R&D status for an innovative crystal calorimeter for the future Muon Collider

Development of a prototype superconducting radio-frequency cavity for conduction-cooled accelerators

Low Noise Cold Electronics System for SBND LAr TPC

SiC Based Beam Monitoring System for Particle Rates from kHz to GHz

FLASH Beam-Off RF Measurements and Analyses

Improving Interface Physics Understanding in High-Frequency Cryogenic Normal Conducting Cavities

From Nuclotron Synchrotron to NICA Collider– Common Cryogenic Concept for Various Superconducting Magnets, their Design Specifics and Test Results

Octagonal Double Transformer SQUID Sensors with Large Input Inductance for Cryogenic Current Comparator

Superstructures For High Current Fel Application

High-power test results for a cylindrical-shell silicon carbide higher-order-mode damper

A Circuit Design for Front- End Read- out Electronics of Beam Homogeneity Measurement

The New Beam Current Transformer for IR-FEL Facility at NSRL *

Design and Low-Power RF Test of a C-band Cryogenic RF Gun

A dynamic collimation and alignment system for the Helmholtz linear accelerator

Thermal Performance Analysis and Operation of the Spoke Cavity Cryomodules for C-ADS Injector-I