Abstract:The Yb:fiber based high-power and high-energy ultrafast lasers usually feature central wavelength of 1030 nm instead of the more common one of 1064 nm, thus limiting some potential wavelength-dependent applications. In this work, a hectowatt 1064-nm femtosecond chirped pulse amplification (CPA) system based on double-stage rod-type photonic crystal fiber (PCF) amplifier was demonstrated, with a pulse energy of 212-μJ and a repetition rate of 0.5 MHz. Compared with our previous work [Opt. Express 30(6), 3611, 2022], two key measures were employed. Firstly, a Yb:YAG crystal was intentionally introduced as a spectral filter for avoiding 1030-nm amplified spontaneous emission (ASE) oscillation, which hence improved the signal-to-noise ratio (SNR) by 15 dB. Secondly, an additional stage of rod-type PCF amplifier was adopted for further power scaling, achieving an average power of 127 W. Finally, the pulse was compressed to ∼460 fs, with an average power of 106 W and a compression efficiency of ∼83%. The beam quality factors (M2) were measured to be M2 X = 1.12 and M2 Y = 1.09. To the best of our knowledge, this is the highest pulse energy among 1064-nm hectowatt-level femtosecond lasers, thus providing a high-quality source for wavelength-dependent applications. For example, it can be used as a driver for high-repetition-rate vacuum ultraviolet (VUV) sources about 10.5 eV, with an expected conversion efficiency of up to 1%.

2.6mJ/100Hz CEP stable near-single-cycle 4μm laser based on OPCPA and hollow-core-fiber compression

Fiber-solid, Hybrid, Single-Frequency Laser (100 W) with a 100 MHz Repetition Rate and 1 Ns Pulse Width from a Spherical Aberration Compensated Four-Stage Nd:YVO4 Amplifier

CEP-Stable, Few-Cycle, kHz OPCPAs for Attosecond Science: Energy Scaling and Coherent Sub-Cycle Pulse Synthesis

High-energy, Phase-Stable, Ultrabroadband Khz OPCPA at 21 Μm Pumped by a Picosecond Cryogenic Yb:YAG Laser

High-power 0.4-mJ picosecond CPA system based on an extra-large-mode-area triple-clad fiber

75 MW few-cycle mid-infrared pulses from a collinear apodized APPLN-based OPCPA

10-µJ-level femtosecond pulse generation in the erbium CPA fiber source with microstructured hollow-core fiber assisted delivery and nonlinear frequency conversion

Old Wavelength, New Performance: Hectowatt 200-μJ-level Femtosecond fiber CPA System at 1064 Nm

Soliton-effect self-compressed single-cycle 9.6-W mid-IR pulses from a 21-W OPCPA at 3.25 μm and 160 kHz

Table-top high-energy 7 um OPCPA and 260 mJ Ho:YLF pump laser

Narrow-Linewidth 2 μm All-Fiber Laser Amplifier with a Highly Stable and Precisely Tunable Wavelength for Gas Molecule Absorption in Photonic Crystal Hollow-Core Fibers

Broadband High-Power Mid-Ir Femtosecond Pulse Generation from an Ytterbium-Doped Fiber Laser Pumped Optical Parametric Amplifier

High-energy, Few-cycle, Khz OPCPA at 2.1 Μm Pumped by a Picosecond Cryogenic Yb:YAG Laser

CEP-stable soliton-based pulse compression to 4.4 fs and UV generation at 800 kHz repetition rate

Mid-infrared pulse generation via achromatic quasi-phase-matched OPCPA

High-Energy, Few-Cycle, Khz Opcpa At 2.1 Mu M Pumped By A Picosecond Cryogenic Yb:Yag Laser

396 MHz CPA femtosecond laser system based on a single crystal fiber rod-type amplifier

Efficient and scalable scheme for overcoming the pulse energy bottleneck of single-cycle laser sources

High Repetition Rate, 4 Μm Mid-Infrared Generation with Periodically Poled Magnesium-Oxide-Doped Lithium Niobate Based Optical Parametric Oscillator Pumped by Fiber Laser

Sub-60-fs, Compact 1100-Nm Fiber Laser System Based on Double-Pass Pre-Chirp Managed Amplification.

Recent Progress and Future Prospects of High-Energy Peta-Watt Laser in LFRC, CAEP