Effect of Dipping Time on Microstructure and Properties of Zn-1Al-2Mg Coating by Hot-Dipping Galvanizing
Ping Zhang,Xu Ding,Honglin Wu,Ruzhong Hu,Xiaojun Zhao,Yuan Wei,Shengmin Wang
DOI: https://doi.org/10.1007/s11665-024-09713-y
IF: 2.3
2024-06-15
Journal of Materials Engineering and Performance
Abstract:The purpose of this study is to investigate the effect of dipping time (30, 60, 90, 120, 150 s) on the microstructure and corrosion resistance of Zn-1Al-2Mg coating under ammonium-free flux. The coatings were prepared at different dipping times, and then the microstructure and composition of the coatings were analyzed by scanning electron microscopy, x-ray diffraction and energy spectrometry; The corrosion resistance of the coatings was evaluated through electrochemical polarization test, neutral salt spray test, and full immersion test. The results show that the Zn-Al-Mg coating consists of Zn-rich phase, Zn/Al/MgZn 2 ternary eutectic, Zn/MgZn 2 binary eutectic phase and Fe-Al alloy phase layer; as the dipping time increases, the coating tends to thicken, and after the 90 s, the coating thickens significantly; while the eutectic structure decreases and the Fe-Al alloy phase thickens, Fe in the substrate continuously diffuses toward the growth direction of the coating and reacts with Al precipitated in the coating to form Fe 2 Al 5 Zn x ; The corrosion products in the Zn-Al-Mg coating, specifically Mg 2 CO 3 (OH) 2 ·3H 2 O and MgCO 3 , increase the pH of the environment and thus slow down the rate of corrosion. The corrosion resistance performance varies nonlinearly from good to poor and then improves again with increasing dipping time.
materials science, multidisciplinary