Abstract:The Ni-Fe-based superalloy GH4169 (Inconel718) is widely used for several critical gas-turbine components which are hot forged. Its microstructure and property are sensitive to the parameter adjustment during hot working process. To obtain required low-cycle fatigue and fracture properties, it is essential that the microstructure is controlled during preheating and heat treatment. The evolution of non-uniform microstructure during hot working is more complicated than that of uniform microstructure. On the other hand, various secondary phases can be observed in GH4169 alloy, thus it is important to investigate the effect of secondary phases on the microstructure evolution during forging process. In this work, the mechanisms of non-uniform microstructure evolution in GH4169 alloy were studied by analyzing the evolution of secondary phases, grain boundary misorientation, grain size and interactions of dislocation. It is found that the volume fraction of 8 phase increases with the increasing of temperature and heating time at the lower temperature. While at the higher temperature, it decreases monotonously with the temperature increasing, but increases first and then decreases to stable value with time increasing. The pinning effect of secondary phases in GH4169 alloy can be concluded that the gamma '' phase and 8 phase precipitated within the grains retain movement of dislocation, the 8 phase precipitated at the grain boundary hinders the nucleation and growth of recrystallized grains, and the carbides limits the grain growth. The frequency of low angle grain boundary decreases with temperature and time increasing, and the mobility of low angle grain boundary increases with temperature increasing. The uniformity of microstructure and the size of equaxied subgrain increases with heating temperature and time increasing. Continuous recrystallization of elongated grain occurs at specific conditions. The mechanisms of non-uniform microstructure evolution during heating process can be concluded as sub grain growth, recrystallized grain growth, and anneal twinning nucleation and growth. The recrystallized grains are formed by the growth of subgrains conducted by the rotation of low angle grain boundary and the movement of dislocation. When the grain growth is pinned, the mechanisms for the energy dissipation is the nucleation and growth of anneal twinning. And the growth of anneal twinning promotes the generation of low angle grain boundaries at the tip of partial anneal twinning.

Order phase transition of HIP nickel-based powder superalloy during isothermal aging

Simulation of Microstructure Evolution of Ni75al2.9v22.1 Alloy with Progressive Aging Mechanisms

Effect of Aging Heat Treatment on Microstructure of Ni-based Single Crystal Superalloys

Precipitation of Intersected Plate-Like Γ′ Phase in Β and Its Effect on Creep Behavior of Multiphase Ni3Al-based Intermetallic Alloy

Effects of Long-Term Aging on the Microstructures and Tensile Properties of Ni-Based Single Crystal Superalloy

Mechanisms of Non-Uniform Microstructure Evolution in Gh4169 Alloy During Heating Process

Microscopic Phase-field Simulation for Microstructure Evolution of Ni(75)Al(x)Cr(25-x)Alloy

Effect of the Δ Phase on the Tensile Properties of a Nickel-Based Superalloy

Precipitation behavior of γ′ phase with a multi-model morphology in the Ni-based superalloy GH4720Li during water quenching and subsequent artificial aging and related mechanisms

The Effect of Long-Term Aging on the Microstructure and Properties of a Novel Nickel-Based Powder Superalloy FGH4113A

Influence of Heat Treatment on Microstructure and Tensile Behavior of A Hot Isostatically Pressed Nickel-Based Superalloy

In Situ Small-Angle Neutron Scattering Study of Precipitation and Evolution Behavior of Secondary Phases in Ni-Based Superalloys

Effect of Long-Term Aging on the Evolution of Γ' and TCP Phases of a Ni3Al Based Single Crystal Superalloy

Directional coarsening behavior of primary γ′ phase in Ni3Al-based superalloy during aging heat treatment

Investigation of Precipitation Behavior of a Novel Ni-Fe-Based Superalloy during High-Temperature Aging Treatment

Ordering Transformation and Age Hardening in a Ni-Cr-W Superalloy

Effect of HIP on precipitations and tensile properties of directionally solidified NiAl/Cr(Mo,Hf) alloy

Tailoring the Microstructure and Deformation Mechanisms of an Additively Manufactured Nickel-Based Superalloy by Post-Aging Heat Treatment

High Cycle Fatigue and Fracture Behaviour of a Hot Isostatically Pressed Nickel-Based Superalloy

Transformation of Η-Phase into Γ’-Phase, Γ-Matrix and Its Effect on the High Temperature Hardness and Compression of Fe-Ni-Based A286 Heat-Resistant Superalloy

Effect Of Hot Isostatic Pressing And Aging On Microstructure And Properties Of Nial Alloy