Abstract:The extraordinary mechanical and physical properties of carbon nanotubes (CNTs) have provided the impetus in developing a new promising CNT/carbon (CNT/C) composite, which may effectively alleviate the shortcomings of sharp-angle and thin-walled C/C components in mechanical performance. Present researches on preparing CNT/C composites focus on infiltrating pyrocarbon into CNT assemblies such as array, block, sheet, film, and buckypaper using complicated and time-consuming methods. Here, we report a facile and efficient strategy for preparing CNT fiber/C composites via electrified preform heating chemical vapor infiltration. Densification process is identified as continual deposition of pyrocarbon around CNTs (called coaxial structure) and further deposition among them, which can be accomplished in short time. Small-diameter (below 500 nm) coaxial structures give composites high deformability; larger ones coupled with bridging action of pyrocarbon among them result in better load transfer and more conductive pathways. Optimized CNT fiber/C composites demonstrate impressive tensile strength (205 MPa) and excellent conductivity (431 S/cm), which are comparable to the previously reported C/C and CNT/C composites. Moreover, such composites exhibit lightweight (1.21 g/cm(3)), good deformability and high fracture strain. Our work could open up a general strategy for efficiently fabricating various high-performance CNT/C composites that could be used in high-temperature aerospace fields. (C) 2019 Elsevier Ltd. All rights reserved.

High-strength and toughness carbon nanotube fiber/resin composites by controllable wet-stretching and stepped pressing

Carbon-nanotube-templated Carbon Nanofibers with Improved Mechanical Performance

Reducing Dispersity of Mechanical Properties of Carbon Fiber/epoxy Composites by Introducing Multi-Walled Carbon Nanotubes

Preparation of carbon nanotube/epoxy composite films with high tensile strength and electrical conductivity by impregnation under pressure

Carbon Nanotube/Epoxy Composites Fabricated by Resin Transfer Molding

Tensile Mechanical Behaviors of High Loading of Carbon Nanotube/Epoxy Composites via Experimental and Finite Element Analysis

Influence of Carbon Nanotube Coatings on Carbon Fiber by Ultrasonically Assisted Electrophoretic Deposition on Its Composite Interfacial Property.

A Novel Continuous Carbon Nanotube Fiber/carbon Composite by Electrified Preform Heating Chemical Vapor Infiltration

A Modified Spray-Winding Approach to Enhance the Tensile Performance of Array-Based Carbon Nanotube Composite Films

Full on-line preparation of polymer composites reinforced with aligned carbon nanotubes

Improving Tensile Properties of Double-Walled Carbon Nanotube Strands by Intercalation of Epoxy Resin

On line construction of carbon nanotube/polytriazole composite films with high tensile and heat resistant properties

Carbon fiber/epoxy composite property enhancement through incorporation of carbon nanotubes at the fiber-matrix interphase – Part II: Mechanical and electrical properties of carbon nanotube coated carbon fiber composites

High-strength composite fibers: realizing true potential of carbon nanotubes in polymer matrix through continuous reticulate architecture and molecular level couplings.

Fabrication and properties of aligned multiwalled carbon nanotube-reinforced epoxy composites

Producing Superior Composites by Winding Carbon Nanotubes Onto A Mandrel under A Poly(Vinyl Alcohol) Spray

Preparation and functional study of epoxy composites reinforced with ultra-low content single-walled carbon nanotubes

Preparation and Properties of Carbon Fiber/Carbon Nanotube Wet-Laid Composites

Bio-Inspired Aggregation Control of Carbon Nanotubes for Ultra-Strong Composites

Super-tough and strong nanocomposite fibers by flow-induced alignment of carbon nanotubes on grooved hydrogel surfaces

Strengthening Carbon Nanotube Fibers with Semi-Crystallized Polyvinyl Alcohol and Hot-Stretching