Abstract:This paper describes the results of a back analysis of pillar failures at Troy Mine, Montana, and the use of this experience to make forward predictions on pillar stability in the nearby Montanore deposit which lies in a similar geomechanical setting. At Troy Mine, a progression of pillar failures in areas within the Middle Quartzite of the Revett formation led to the observed surface subsidence. The Troy Mine experience was used to understand the level of stresses and failure mechanism leading to the collapse of some pillars in the North Orebody to estimate pillar strength in quartzite beds within Troy's mountainous terrain. The model elucidated that the dipping orebody geometry in relation to topography led to shear stresses in pillars at Troy Mine. Shear stresses resulted in significant loss of confinement in pillar cores (many theoretically in tension), even at width-to-height ratios that would be deemed stable under zero shear stress (flat seam under flat topography). A calibrated model was achieved, which allowed us to evaluate the impact that different pillar geometric characteristics (such as width, length, height, and shape) have on pillar performance under shear conditions for different depths and extraction ratios. Design charts were then generated to provide guidance on pillar geometry based on expected demand. Mine-wide models were developed to predict the level of vertical stress and horizontal shear stress for pillars in the different ore-bearing beds at Montanore. A sensitivity study was performed for various conditions, including extraction ratio, spatial location under the mountainous terrain, and local orebody geometry with the aim of performing a mine-wide evaluation of the factor of safety against shear. The results of the analyses performed in the present work show that the use of design methods that do not take the effect of shear stresses into account may result in under-designed pillars, while a false impression of rock mass strength could be derived from back analysis.

3D Modelling approach to identify parametric configurations for pillar stability in underground metal mine: a case study

Stability analysis of underground mine hard rock pillars via combination of finite difference methods, neural networks, and Monte Carlo simulation techniques

Three Dimensional Finite Element Analysis of Parameters of Boundary Crown Pillar in Transition from Open-pit to Underground Mining

Analysis on Stability of Top Pillar When Coming into Underground Mining from Open-Pit

Investigation and Stability Assessment of Three Sill Pillar Recovery Schemes in a Hard Rock Mine

Rational size and stability analysis of horizontal isolated pillars in deep mining from caving to filling method

Stability Analysis of Pillars in Underground Limestone Mine Using Three-Dimensional Scanning Techniques

Performance of a coal pillar at deeper cover: Field and simulation studies

Effect of Shear Stresses on Pillar Stability: A Back Analysis of the Troy Mine Experience to Predict Pillar Performance at Montanore Mine

Coal pillar failure analysis and instability evaluation methods: A short review and prospect

Numerical Study of Failure Mechanisms and Control Techniques for a Gob-Side Yield Pillar in the Sijiazhuang Coal Mine, China

Investigation of Rock Mass Stability Around the Tunnels in an Underground Mine in USA Using Three-Dimensional Numerical Modeling

Numerical and theoretical analysis of multi-pillar instability under elastic beams

Study on Ultimate Strength and Dip Effect of Coal Pillar in Steeply Dipping Coal Seam

Instability mechanism and stability control of gob-side entry in a deep mine: a case study

Stability Of Boundary Pillar Of Open Pit And Underground Mine

Stability analysis of 'roof-coal pillar' structure in longwall multi-section mining of steeply dipping coal seam

Hydro-Mechanically Coupled Numerical Modelling of Protective Water Barrier Pillars in Underground Coal Mines in India

Determining the minimum thickness of a crown pillar and optimizing the cross-sectional size of point pillars for the safe exploitation of a subsea gold mine

Rock Mass Stability Investigation Around Tunnels in an Underground Mine in USA

Estimating shear strength of high-level pillars supported with cemented backfilling using the Hoek–Brown strength criterion