Abstract:Currently, the development of industrial waste recycling processes that reduce the anthropogenic load on the biosphere and ensure the rational use of natural resources is an urgent task. Technogenic waste from ferrochrome production contains chromium, which is one of the most toxic components of industrial waste. To extract chromium from them, the most acceptable method is acid leaching. The purpose of the work is to study the influence of temperature, process duration and H2SO4 concentration on the extraction of chromium from high-carbon ferrochrome slag into a sulfuric acid solution. Using mathematical planning of a 3-factor experiment, experiments were carried out to extract chromium from the slags of high-carbon ferrochrome production. The H2SO4 concentration was varied from 5 to 95% by diluting the concentrated acid. The duration of the process ranged from 10 to 180 minutes at S:L = 1:30, the temperature varied from 22 to 90 °C. Results and discussion. The maximum transition of chromium into acid occurs at a temperature of 76-90 °C and a process duration of 145-180 minutes. The degree of extraction reaches 97.9%. The smallest amount of chromium, about 20 mg/L, passes into the weakly concentrated H2SO4 solution, the degree of leaching is low and equal to 20.6%. When using 50% H2SO4, the highest degree of transition of Cr (94.8%) from ferrochrome slag to sulfuric acid occurs at a high temperature of 90 °C in 150-180 minutes. Deeper extraction of chromium cations into acid occurs at 80-90 °C. The maximum content of Cr3+ in the acid is achieved in 46-107 minutes and amounts to (0.33-0.68)%. Conclusions. It was revealed that with increasing process duration and increasing temperature, the degree of extraction increases. The maximum transition of chromium into acid from high-carbon ferrochrome slag occurs at a temperature of 76-90 °C and a process duration of 145-180 minutes. The degree of extraction reaches 97.9%. An increase in the temperature of the process of leaching chromium from VUVC with concentrated sulfuric acid initiates the extraction of chromium from the raw material.

Experimental Study on Preparation of Ferrochrome by SHS

Behavior of chromium in the reduction and smelting of high alumina nickel laterite in blast furnace

Preparation of Al-Cr-Fe Coatings by Heat Treatment of Electrodeposited Cr/Al Composite Coatings

Preparation of ferrochromium nitride via reduction and nitridation of chromite spinel with ammonia gas

Chromium Recovery from Ferro-Chromium Slags

Production of complex Fe-Si-Mn-Cr ferroalloy using high-ash coal: a sustainable metallurgical approach

Review on Preparation of Medium- and Low-carbon Ferrochrome Alloys

"THERMODYNAMIC MODELING OF THE SMELTING PROCESS OF A NEW COMPLEX CHROMIUM-MANGANESE-SILICON CONTAINING FERROALLOY"

EXTRACTION OF CHROME FROM FERROCHROME PRODUCTION SLAG USING THE SULFURIC ACID METHOD

Enrichment Characteristics of Cr in Chromium Slag after Pre-Reduction and Melting/Magnetic Separation Treatment

Study on Zinc Volatilization in the Process of SHS Ni-Zn Ferrite Powder

The Direct Alloying of Steel through Silicothermic Self-Reduction of Chromite Ore Utilizing Si-Containing Solid Waste

Ferrochrome Production in a Submerged Electric Arc Furnace: Fundamental Analysis Based upon the FactSage‐Macro Program Approach

STUDY ON SYNTHESIS OF Ni0.35Zn0.65Fe2O4 FERRITE BY SHS METHOD

Preparation of high-quality FeV50 alloy by an improved SHS-EAH multi-stage process

Fe microalloying during the in-situ synthesis of homogeneous CuCrFe alloys by aluminothermic Self-propagating

Value Extraction from Ferrochrome Slag: A Thermochemical Equilibrium Calculation and Experimental Approach

Experimental investigation on the formation mechanism of the TiFe alloy by the molten-salt electrolytic titanium concentrate

Characterization of a Chromium-Bearing Carbon Steel Electric Arc Furnace Slag after Magnetic Separation to Determine the Potential for Iron and Chromium Recovery

Hydrogen-based pre-reduction of chromite: Reduction and consolidation mechanisms

Selective Complex Precipitation for Ferro-Chrome Separation From Electroplating Sludge Leaching Solution