Abstract:In order to overcome the drag at hypersonic speed, hypersonic flight vehicles require a high level of integration between the airframe and the propulsion system. Propulsion system based on scramjet engine needs a close interaction between its aerodynamics and stability. Hypersonic vehicle nozzles which are responsible for generating most of the thrust generally are fused with the vehicle afterbody influencing the thrust efficiency and vehicle stability. Single expansion ramp nozzles (SERN) produce enough thrust necessary to hypersonic flight and are the subject of analysis of this work. Flow expansion within a nozzle is naturally 3D phenomena; however, the use of side walls controls the expansion approximating it to a 2D flow confined. An experimental study of nozzle performance traditionally uses the stagnation conditions and the area ratio of the diverging section of the tunnel for approaching the combustor exit conditions. In this work, a complete hypersonic vehicle based on scramjet propulsion is installed in the test section of a hypersonic shock tunnel. Therefore, the SERN inlet conditions are the real conditions from the combustor exit. The performance of a SERN is evaluated experimentally under real conditions obtained from the combustor exit. To quantify the SERN performance parameters such as thrust, axial thrust coefficient C f x and lift L are investigated and evaluated. The generated thrust was determined from both static and pitot pressure measurements considering the installation of side walls to approximate 2D flow. Measurements obtained by a rake show that the flow at the nozzle exit is not symmetric. Pitot and pressure measurements inside the combustion chamber show nonuniform flow condition as expected due to side wall compression and boundary layer. The total axial thrust for the nozzle obtained with the side wall is slightly higher than without it. Static pressure measurements at the centerline of the nozzle show that the residence time of the flow in the expansion section is short enough and the flow of the central region of the nozzle is not altered by the lateral expansion when nozzle configuration does not include side walls.

Design and Evaluation of Aerospike Nozzles for an Upper-Stage Application

Numerical Simulation and Design for Aerospike Nozzle

Numerical study on aerospike nozzle flowfields for SSTO applications

Development and simulation of a 3D printed liquid oxygen/liquid natural gas aerospike

Design and Optimization of Three-Dimensional Supersonic Asymmetric Truncated Nozzle

Design and optimization of aerospike nozzle for rotating detonation engine

Surface Pressure Measurement of Truncated, Linear Aerospike Nozzles Utilising Secondary Injection for Aerodynamic Thrust Vectoring

Experimental and Numerical Studies on Tile-Shaped Aerospike Nozzle

Aeroacoustic design and broadband noise predictions of a fan stage with serrated outlet guide vanes

Shock Wave and Aeroelastic Coupling in Overexpanded Nozzle

Design and simulation of a micro thrust solenoid valve nozzle based on CFD&DOE optimization analysis

Experimental Research of the Performance and Pressure Gain in Continuous Detonation Engines with Aerospike Nozzles

Aerodynamic Design Of A Highly Loaded Supersonic Aspirated Axial Flow Compressor Stage

Structure Design and Performance Investigation of a Novel Rotatable Vane Nozzle

Experimental Study of Single Expansion Ramp Nozzle Performance Using Pitot Pressure and Static Pressure Measurements

Process qualification, additive manufacturing, and postprocessing of a hydrogen peroxide/kerosene 6 kN aerospike breadboard engine

Study on the Influence of Angle of Attack on the Aerodynamic Performance of Aerospike Structure of Hypersonic Vehicle

Integrated Optimization of Ascent Trajectory and SRM Design of Multistage Launch Vehicles

Design and Simulation of Variable Area Jet Nozzle with Asymmetrical Attitude Simulation

Structural design and flow field analysis of the variable nozzle of turbocharger

CFD-Driven Optimization of Dual-Throat Micro-Nozzle for Enhanced Thrust in Cold Gas Propulsion for Microsatellites