Abstract:In variable nozzle geometry turbines (VNT), opening of the nozzles is used to control turbine mass flow and expansion ratio, allowing more turbine power to be generated over wider operating conditions. In turbocharged vehicles, the nozzles are 'closed' to provide high boosts for engine and vehicle acceleration and for engine braking assistance. At the both conditions, high nozzle expansion ratios are created , and shockwaves may generate from the nozzles. These shocks reduce turbine efficiency and they can cause high cycle fatigue (HCF) damage to the downstream rotor blades. Design of high expansion ratio radial nozzles is difficult for VNT because transonic flows are very sensitive to small geometry changes, and the large semi-vaneless space created by the nozzles makes the design a tricky business. Shock minimised nozzle designs are therefore often achieved by auto-optimisation technique. While design targets may be achieved, this technique does not offer sufficient insights into how the optimal flow field has been derived, so the same optimisation procedure has to be applied to every new design. In this paper, a new design method that overcomes this problem is proposed. The method first uses a conformal mapping to transfer a radial nozzle from the r-θ plane into the x-y plane. Mapped nozzle displays amplification of supersonic acceleration and diffusion. This is explained by the curvature changes brought about by the mapping, and a link between the shock strength and the flatness of the suction surface of the mapped nozzle is found. The amplification and the link can be utilised to design nozzles with reduced shock loss in the x-y plane first and then mapped back to the r-θ plane. Two nozzles for 6:1 expansion ratio were designed in this way and CFD results show a significant reduction of nozzle loss. The nozzles were also checked for fully open condition and no performance penalty was found.

Design and simulation of a micro thrust solenoid valve nozzle based on CFD&DOE optimization analysis

Design and Optimization of Three-Dimensional Supersonic Asymmetric Truncated Nozzle

Flow Force Analysis and Structural Optimization of a Large Flow Rate Pressure Compensation Valve

CFD-Driven Optimization of Dual-Throat Micro-Nozzle for Enhanced Thrust in Cold Gas Propulsion for Microsatellites

Modeling and Analysis of Fluid-Solid Coupling Heat Transfer and Fluid Flow in Transonic Nozzle

CFD Simulation of Dynamic Characteristics of a Solenoid Valve for Exhaust Gas Turbocharger System

Optimization design of hydrogen Laval nozzle based on response surface methodology (RSM)

Numerical Simulation and Design for Aerospike Nozzle

Research on Laval Nozzle and Overall Simulation Analysis Based on High Speed Precision Air Bearing Spindle Pneumatic Turbine System

Optimization of Solenoid Parameters for a Magnetic Nozzle Assembly Using Design of Experiments

Numerical investigations of the nozzle performance for a rocket-based rotating detonation engine with film cooling

Structural design and flow field analysis of the variable nozzle of turbocharger

Numerical Simulation of Inner Flow Field of a Pintle Injector Variable Thrust Rocket Engine

Multi-Objective Parameter Optimized Design of Self-Oscillating Cavitation Jet Nozzles

A New Design Method of Single Expansion Ramp Nozzles under Geometric Constraints for Scramjets

Multi-objective parameters optimization design of self-excited oscillation pulsed atomizing nozzle

Simulation and Optimization of the Nozzle Section Geometry for a Suspension Abrasive Water Jet

A novel design method of variable geometry turbine nozzles for high expansion ratios

Aerodynamic Optimization of Turbine Based Combined Cycle Nozzle

Optimal Design of Ejector Nozzle Profile with Internal and External Integrated Flow

Design and numerical analysis on a solid micro-thruster