Abstract:In variable nozzle geometry turbines (VNT), opening of the nozzles is used to control turbine mass flow and expansion ratio, allowing more turbine power to be generated over wider operating conditions. In turbocharged vehicles, the nozzles are 'closed' to provide high boosts for engine and vehicle acceleration and for engine braking assistance. At the both conditions, high nozzle expansion ratios are created , and shockwaves may generate from the nozzles. These shocks reduce turbine efficiency and they can cause high cycle fatigue (HCF) damage to the downstream rotor blades. Design of high expansion ratio radial nozzles is difficult for VNT because transonic flows are very sensitive to small geometry changes, and the large semi-vaneless space created by the nozzles makes the design a tricky business. Shock minimised nozzle designs are therefore often achieved by auto-optimisation technique. While design targets may be achieved, this technique does not offer sufficient insights into how the optimal flow field has been derived, so the same optimisation procedure has to be applied to every new design. In this paper, a new design method that overcomes this problem is proposed. The method first uses a conformal mapping to transfer a radial nozzle from the r-θ plane into the x-y plane. Mapped nozzle displays amplification of supersonic acceleration and diffusion. This is explained by the curvature changes brought about by the mapping, and a link between the shock strength and the flatness of the suction surface of the mapped nozzle is found. The amplification and the link can be utilised to design nozzles with reduced shock loss in the x-y plane first and then mapped back to the r-θ plane. Two nozzles for 6:1 expansion ratio were designed in this way and CFD results show a significant reduction of nozzle loss. The nozzles were also checked for fully open condition and no performance penalty was found.

Aerodynamic Optimization of Turbine Based Combined Cycle Nozzle

Multi-objective Optimization of Transpiration Cooling for High Pressure Turbine Vane

Performance Sensitivity Analysis and Aerodynamic Optimization of Compressor Cascades by a Turbulence Adjoint Method

A throughflow-based optimization method for multi-stage axial compressor

Design and Optimization of Three-Dimensional Supersonic Asymmetric Truncated Nozzle

Aerodynamic Shape Optimization of a Transonic Fan by an Adjoint-Response Surface Method

Multi-Objective Design Optimization of a Transonic Compressor Rotor Using an Adjoint Equation Method

Simulation of Optimization of Variable Geometry for a Turbofan Engine of a Missile

Aerodynamic Design Optimization of a Variable Geometry Nozzle Vane For Automotive Turbochargers

Advanced Aerodynamic Optimization System for Turbomachinery

Integrated optimization method for transonic turbine based on direct free-form deformation and prescreening differential evolutionary optimizer

Thrust-matching and optimization design of turbine-based combined cycle engine with trajectory optimization

Coupled Aerothermodynamics Optimization for the Cooling System of a Turbine Vane

Optimization of a high through-flow design turbine using response surface method

Research on an optimization design method for a TBCC propulsion scheme

Three-Dimensional Aerodynamic Optimization of a Multi-Stage Axial Compressor

A novel design method of variable geometry turbine nozzles for high expansion ratios

Structural design and flow field analysis of the variable nozzle of turbocharger

A cooled turbine blade design and optimization method considering the cooling structure influence

Aerodynamic Optimization of a High-Expansion Ratio Organic Radial-Inflow Turbine